- Activate the metal key.
- Using a little screwdriver, press the key’s back cover.
- At the fob’s end, lift the back cover.
- The battery should be inside if the back cover is removed.
- Remember the orientation before removing the battery.
- The battery needs to be replaced correctly.
What occurs if the battery on an Audi key dies?
Early Audi vehicles lack a Start/Stop button in favor of using a slot in the dashboard. To start or stop the car, one must push the actual fob. The car will already detect the key fob when inserted, even if the battery is dead.
Why isn’t my Audi key working?
Audi models from 2000 to 2014, including the Q5, R8, A6, A8, Q7, A4, A3, TT, Allroad, A5 and A7, are covered by this TSB.
Although central locking by remote control no longer functions either continuously or intermittently, the locks can still be opened by hand. Because the battery has been disconnected or the remote control’s battery has been changed, the remote control key and vehicle may not be in sync. The remote control key may have been momentarily turned off if other senders (such as mobile phones, TV stations, wireless headphones, etc.) use the same frequency band. This is because it is impossible to clearly indicate the remote control key. This is required to stop other unconnected senders from accidentally unlocking the car.
To synchronize each remote control key with the car, do the following:
- Use the key to mechanically start the car.
- Depress the remote control key’s unlock button.
- Turn the ignition switch to the ON position after inserting the key.
- Reset the key to OFF and take it out of the lock.
- Press the remote control key’s locking or unlocking button.
- 2002 model year or later: Use the VAS scan tool to program the remote control key(s) to the Central Comfort System control module (address word 46) if the synchronization procedure did not work. Implement test plan J393-central control module for comfort system while adjusting the remote control key (channel 21). Sometimes after the “The test strategy of erasing all memory places first yields better outcomes.
- On the remote control key, press a button.
- With the key, lock or unlock the car once mechanically.
- The entire operation cannot go on for more than 30 seconds.
- Up until and including model year 2009: Use the VAS scan tool to program the remote control key(s) to the Central Comfort System control module (address word 46) if the synchronization procedure failed. adopting the remote control key and testing plan J393central control module for comfort system (s). occasionally after “The test strategy of erasing all memory places first yields better outcomes. Adapt the remote control key(s) to the BCM2 (vehicle electrical system control unit), address word 09, using the VAS scan tool, starting with model year 2010 if the synchronization procedure did not work. Adapt the remote control key as per test plan J519-Vehicle Electrical System Control Module (s).