- Step 1: Get the bolts ready. Into your Audi’s cargo space you go.
- Jack up the automobile in step two. Grab your jack and place it beneath your vehicle now.
- 3. Remove the steering wheel. Take hold of the wheel firmly with both hands and remove it.
- Install the spare or new tire in Step 4.
In This Article...
An Audi A4’s jack can be found where?
- On a solid, flat surface, park the car as far away from oncoming traffic as you can.
- Turn on the parking brake.
- Turn on the hazard lights.
If there are any passengers in your car, ask them to get out and go somewhere safe.
Audi A4 Flat Tire Equipment
You should have a vehicle tool kit, tire mobility kit, and vehicle jack in your car, all of which may be found in the trunk’s luggage area underneath the cargo floor cover (trunk).
- Pull the strap holding the cargo floor cover up to reveal the front compartment (1).
- Pick up the cargo floor by the plastic handle to access the rear compartment (2).
- (2) Secure the plastic handle to the seal on the baggage compartment
- Pull the plastic lever of the cargo floor toward the back to completely remove it (2).
- If your car has a spare tire, turn the handle in the other direction to take it off.
- Before locking the lead on your trunk, unhook the cargo floor.
Depending on the vehicle’s accessories, the compressor, tire mobility kit, and tool kit may all be concealed under a different cover that is fastened with a hand wheel.
If your vehicle has a storage bag for the jack, the storage bag is fastened with tie-straps in the baggage area and needs to be fastened again after use.
Using The 2020 Audi A4 Tire Mobility Kit
The use of slime to inflate a flat tire is only a temporary solution. If feasible, replace the damaged tire right away. Never remove a nail or other sharp object that has punctured a tire from the tire. Temperatures as low as (-4F) or below can be used with the tire mobility kit (-20C).
How should the jack on an Audi A4 be used?
If you are jacking up the front wheel, the jack goes directly behind it; if you are jacking up the rear wheel, the jack goes directly in front of it. There ought to be a small mark along the rail. Start elevating the car after positioning the jack beneath the location. Lift the car high enough for a jack stand to fit beneath.
Where is the jack in the 2017 Audi A4?
Always give the jack* a stable platform on the ground. (The vehicle’s tool kit has the jack.) Use a sizable, sturdy board or another type of support if necessary. To stop the jack from slipping on a hard, slippery surface (like tiles), use a rubber pad or something comparable.
Find the Fig. 315o indication on the door sill that is closest to the wheel that needs to be changed. The indication under the door sill is in front of the jacking point.
When the jack’s claw completely encircles the seam on your car, turn the knob to wind up the jack* underneath the jacking point on the door sill.
Place the jack* so that its base plate is flat on the ground and its claw (A) fits around the seam. The jacking point (A) must be supported vertically by the base plate (B).
Now attach the crank handle to the jack by fitting it into the knob’s aperture. To fix the crank handle in place, turn it either clockwise or counterclockwise.
Wind the crank handle to raise the car till the broken wheel is off the ground.
- Verify the jack’s stability. The jack runs the risk of slipping or sinking in if the ground beneath it is slick or mushy.
- To raise the car, only use the jack* that came with it. The risk of injury increases if you use a jack from another vehicle because your car can slide off the jack.
- Only use the jack* at the jacking points that are behind the door sill markings, and make sure it is properly aligned. If the jack* is not correctly engaged, there is a danger of damage since it may suddenly slip off.
- Never start the engine when the chance of an accident is high!
- If work is to be done below the vehicle, make sure it is securely supported on appropriate supports to reduce harm risk!
It is forbidden to raise the car on its sills. Only use the jack* at the jacking locations that are behind the door sill markings. In the absence of that, your car can be harmed.
Audi A4 Toolkit: Where Is It?
Some Audi A4s have an additional cover, maybe with a knob, that conceals the tools, compressor, and tire repair kit. The tool kit can be found behind the back seats of some Audi A4s, right behind the floor panel (Fig. 2A).
How much does a tire change cost for an Audi A4?
Best in Automotive Repair The average price to replace a wheel on an Audi A4 is from $1,033 to $1,047. The cost of labor is expected to be between $55 and $69, while the cost of the parts is $978.
In an Audi A4, where is the locking wheel nut located?
The tool bag with the lung wrench and the wheel lock key are typically located next to each other in the foam under the floor. The tool bag with the lung wrench and the wheel lock key are typically located next to each other in the foam under the floor.
What size lug nuts fit an Audi?
They are 17mm, but a plastic cover that appears to be around 21mm thick is placed on top of them. You can take them out with a little gripper instrument that resembles tweezers.