When the wipers are halfway down your windshield, switch them ON before turning them off on your Audi Q5.
In This Article...
Lift your wipers up from the windshield
It should be simple to lift your wipers up and away from your windshield once they are stopped halfway on your windshield. The old wipers on your windshield should protrude and point away from you. Now providing for simple access throughout the remaining modifying procedure.
Before you remove old wiper blades
Make sure to note which side the new blade length belongs on. Measure the previous blades’ length or simply compare it to the new Trico wiper blades. Then, position the fresh blades on the appropriate side.
Remove old wiper blades
The windshield wipers on your 2010 Audi Q5 are operated by a “Narrow” 19mm Push Button attachment. Click the button or tab. Slide the old wiper off after that.
Various wiper manufacturers employ various push button attachment styles.
Connect the new Trico Tech Beam Blade wipers
When using this arm type, the preattached adaptor on the wiper blade must be removed and replaced as shown with the adapter (BC)
1. Move the tiny adapter lever in the direction of the blade’s center.
2. As you complete step 1, remove the factory-installed adaptor from the blade and throw it away.
3. Locate the BC adaptor and place it in the blade’s middle. the two protrusions inside the adaptor onto the “X”-marked region of the blade.
4. Push the tab on the adaptor’s front (B).
5. Remove shim (C) from adaptor (B) and throw it away. Tip: To remove shim (C) more easily, press down on the top edge of adaptor B.
6. Connect the tabs on the adaptor’s back end.
7. Draw the blade into the arm’s underside.
8. The hole on the top of the arm must lock the button on the adaptor’s top into place.
What is Audi Wiper Position Change?
You don’t have to go through the infotainment center to reach the “Wiper Change Position.” Simply turn the ignition off and depress the wiper leaver to place the car in the wiper change position. For people living in northern climates, this is the best way to stop the wiper blade from freezing to the windshield.
On an Audi Q7, how do you take the rear wiper arm off?
How to Replace the Rear Windshield Wiper Arm on an Audi Q5 or Q7
- Step 1: Take off the plastic cover. At the base of the arm, where it connects to the car, pull off the plastic cover.
- Step 2Take the nut off the arm. A 13mm nut secures the wiper arm in place.
- 3. Remove the wiper arm. Take the wiper arm off.
- Install a replacement arm in Step 4.
How is a rear windshield wiper removed?
If a service technician changed the wiper arm as part of the service, follow these instructions to replace the wiper blade on the back window.
applies to V60, V60CC, and V60H models made before to 15W26 when the wiper arm is replaced during maintenance.
To loosen and remove the blade, take a firm hold of the wiper arm and press the blade forward (at the arrow).
Car model/model year
V60 up to and including the 2016 model year applies to vehicles in which the wiper arm is changed during maintenance.
Consult the relevant model’s online handbook for vehicles starting with the model year 2020.