Start the automobile, then wait around five minutes for the engine to warm up.
Locate the automatic transmission fluid dipstick by opening the hood. Just to the left of the battery, there is a T-shaped handle that houses the dipstick. The vehicle should still be in motion.
Take out the dipstick, then clean it with a fresh towel. Replace the dipstick and take it out once more. If the fluid is between the two tiny dots labeled “Cold,” continue to Step 5; otherwise, skip this step. Otherwise, move on to Step 4.
Fill the dipstick tube with the funnel. Incorporate about 1/4 qt. about transmission fluid. Check the level once more, and keep adding liquid until it reaches the “Cold” level.
Close the hood after replacing the dipstick. Drive the vehicle for about five miles.
Shut off the engine and raise the hood. The dipstick should be taken out and cleaned with the rag. Remove and replace the dipstick. Now, if the fluid level is not between the two “Hot” dots, add fluid as directed in Step 4. Replace the dipstick and shut the hood once the fluid level is correct.
In This Article...
rogoman
Always replenish the CVT fluid at 60,000 miles or sooner. Long-term immersion of the fluid damages its chemical composition, making it incapable of providing the crucial cushion between the steel belt and the cones.
You have the option of doing it yourself or hiring a local company to replenish the fluid. 5 qts of genuine Nissan NS-2 CVT fluid cost about $90 on Amazon. A new washer should be used for the drain plug, and 4.25 quarts of Nissan NS-2 fluid should be poured in for a straightforward drain and fill. Make careful to drive the vehicle slowly for about 30 minutes to thoroughly warm up the CVT. Let it idle for a moment, then slowly pour some fluid in. Check your dipstick to see if it’s full, then add more. until it reaches the entire mark, just a little at a time. After another 15 minutes or so of driving, check the fluid level while the engine is idle.
A 2009 Nissan Altima uses what kind of transmission fluid?
Full synthetic automatic transmission fluid from Valvoline called MaxLife Multi-Vehicle (ATF), 1 gallon (Part No. 773775)
How does a 2009 Nissan Altima’s gearbox fluid check work?
- Access location for transmission fluid: remove dipstick.
- Check Level: To check the level, insert the dipstick and remove it.
- Add Fluid – Select the proper type of fluid and add it.
- Replace the dipstick by repositioning the dipstick and cap.
How much does a 2009 Nissan Altima transmission cost?
The most dependable vehicle I’ve ever owned was my 2009 Nissan Altima. I’ve only experienced a couple minor issues up to now. The transmission is now dead, though. How much does it cost to replace the transmission on a 2009 Nissan Altima? Should I consider investing in a brand-new Altima instead?
In less than two minutes, find out if your auto insurance is being overcharged.
It might be time to think about getting a new vehicle. The cost to replace the entire transmission in a 2009 Nissan Altima ranges from $4,600 to $5,000, which is marginally less than the typical cost to do so.
Unfortunately, a blown transmission is frequently a significant warning sign that further expensive repairs will need to be made shortly.
Even if the Altima was in excellent condition, the cost to repair the transmission is almost the full worth of the vehicle. The automobile is currently valued between $4,600 and $6,000 according to Kelley Blue Book. So perhaps it’s time to check out a Nissan dealership and see about purchasing a brand-new Nissan Altima.
In as little as 45 seconds, Jerry will offer you with customized quotations from 55+ of the best car insurance companies.
Jerry has saved many Americans, on average, more than $800 annually on their auto insurance. Discover how much money this app can help you save by downloading Jerry today!
A transmission filter is there in a 2009 Nissan Altima?
numerous applications Your Nissan Altima’s transmission filter keeps the fluid in the transmission clean and clear of contaminants. To avoid harming other internal components, transmission filters keep metal shavings, debris, and other impurities out of the transmission.
How does a Nissan Altima’s CVT fluid check out?
- Start the engine of your car and let it idle for a while.
- Find the dipstick for the transmission fluid.
- Touch the fluid with your thumb and forefinger after removing the dipstick.
- To clean up the dipstick, use a rag.
Is a CVT transmission available for the 2009 Nissan Altima?
The 3.5-liter V6 engine in Altima 3.5 variants produces 258 lb-ft of torque and 270 horsepower. The majority of variants come with a six-speed manual transmission as standard (a CVT is an option), with the exception of the base 2.5 and 3.5 SL models.
At what point do I add transmission fluid?
Your car contains several different fluids, but the transmission fluid is one of the most crucial to monitor. There is no question as to whether or not you should update it: Yes, you should. However, the frequency of this service varies by manufacturer and vehicle, and it’s up for argument.
For many automatic gearboxes, the manufacturer’s recommended maintenance interval is 100,000 miles, or even 150,000 miles for select Ford transmissions. Many mechanics contend that is excessively long and that it ought to be performed at least every 50,000 miles. It is important to refer to the owner’s handbook’s service intervals because manual transmissions typically require more traditional gear oil than automatic transmission fluid and have a different maintenance schedule.
Transmission fluid degrades over time, just like other important vehicle fluids. Hard use, such as continuous stop-and-go city driving, towing a trailer, and carrying large loads, will hasten the deterioration. Driving in that manner raises the transmission’s operating temperature, and heat puts additional pressure on the fluid and the transmission. Transmission fluid, which aids in gear shifts, cools the transmission, and lubricates moving parts, differs from engine oil, which acts primarily as a lubricant.
If you drive frequently under stressful circumstances, you should check the transmission fluid level more frequently and have a repair shop examine the fluid’s condition. Although it can come in numerous hues, transmission fluid frequently is red. As it ages, though, it tends to become darker. Additionally, it can start to smell burned, which could mean that it needs to be changed or that the gearbox is experiencing mechanical issues.
How is transmission fluid topped off?
Using a little funnel, top off the fluid levels through the dipstick tube. To avoid overfilling, add a bit at a time and check the level often.
Most gearbox dipsticks have a variation between low and full marks of around 1/2 liter (about 1 pint). Therefore, approximately 1 pint) is required if the reading is in the middle of them.
When topping off the fluid level on a cold engine, fill to 1/2 inch. Below the dipstick full mark, by (13 mm). If not, the temperature will be excessively high at operating temperature and overheating may result.
At specific defined mileages, several car manuals advise emptying and refilling automatic gears.
Draining them requires removing the gearbox sump and dipstick tube, which is a challenging and filthy task.
, a job requiring meticulously clean workspaces and garage facilities. In the owner’s manual or service manual, follow the manufacturer’s instructions.
There are drain plugs on the smaller automatic transmissions, and the fluid needs to be replaced according to the intervals suggested in the car manual.
When the engine oil is changed, those installed in BL automobiles that use the same oil as the engine receive new oil. Others, like those installed in some Volkswagen and Renault vehicles, have their own unique fluid supply.
While the fluid is still at its usual operating temperature, the transmission should be emptied. Be careful since it will be hot enough to result in severe burns.
Most of the time, draining requires lifting the car and carefully securing it to
Put the drain tray under the sump and remove the plug while avoiding getting hot oil on your hands and arms when it gushes out.
Replace the drain plug after the oil has been completely drained, then add new fluid or oil of the kind that the owner’s manual or service manual recommends.
Recheck the level and top it off if necessary after adding the recommended amount of fluid and driving the vehicle until the fresh fluid reaches the proper operating temperature.
Pouring the used fluid down the drain will contaminate the water supply. Find the closest oil disposal landfill by contacting your local authority, then transport the oil there.
Just add the transmission fluid, please.
- Start the engine after parking the car on a flat area. Park or leave the car in neutral. If the owner’s manual for your car doesn’t specify differently, let the engine warm up and run all the way through operation. (Check the owner’s manual; be mindful that some automatic gearbox fluid levels are tested with the engine off.)
- Where the transmission or transaxle meets the back of the engine is normally where you may find the automatic transmission fluid dipstick. It resembles an oil dipstick in appearance.
- Look at the markings on the dipstick’s end. One warm and one cold marking for “full” may be present on your dipstick. You will need to add automatic transmission fluid if the level does not rise to the “warm” line.
- Long funnel should be inserted into dipstick hole for automatic transmission fluid. Add automatic transmission fluid gradually, checking the level after each addition to ensure that it reaches the “warm” line. WARNING: A/T fluid should not be spilled or overfilled on hot engine components!
- Fully reinstall the dipstick for the automatic transmission fluid. You’re finished!
How frequently should the fluid in a Nissan CVT transmission be changed?
How frequently does my Nissan need to exchange the CVT fluid? Around every 30,000 miles, Chapman Nissan advises changing the continuously variable gearbox fluid.
What occurs if a car’s transmission fluid level is low?
Transmission fluid leaks can occasionally be caused by a broken transmission. It makes the fluid levels drop, which has an impact on how well the car works. Driving with low transmission fluid levels could result in expensive, long-lasting car damage that would require pricey repairs.
What happens if my transmission fluid runs out?
The transmission fluid in an automatic car acts as a link between the gearbox’s gears and the engine’s output. Without fluid, there would be no hold, which would prevent the gears from rotating and preventing the car from moving.
You may also need to replace your transmission entirely if your car does eventually reach the point where it is completely devoid of transmission fluid. Your transmission’s metal gears will almost certainly sustain severe damage from the lack of lubrication. Always make an effort to maintain the correct levels and proper maintenance of your transmission fluid.
Can I add fluid to the transmission without flushing?
When you need a quick fix, you might be able to get away with a basic transmission fluid replacement rather than a complete flush, but this won’t keep your transmission safe for very long. In other words, it’s not the best strategy for extending the life of your car. You require a complete fluid flush and replacement because of this. Therefore, you must replace it with exactly the same amount of transmission fluid if your owner’s manual specifies that it carries exactly 15 gallons. Not to mention how much old transmission fluid you should have in the drain pan.
Be aware that when performed by a professional, a thorough transmission fluid flush might cost up to twice as much as simply changing the fluid. However, your car will benefit greatly from it as well. The device that flushes your fluids saves money in the long run if you decide to handle this yourself.