the starting point’s location The speedometer and shift wires from the trans-axle are located next to the starter under the hood. The starter is connected to the car battery by simply following the red positive connection on the battery. also to take the starter out. Simply take off the heat shield, unplug the two red wires from the unit’s back, and then loosen the two bolts. If you’re changing the starting, you’ll need to take the brass stud out of the old starter so you can reassemble it after purchasing the new starter. —————- This will be useful. Thanks. Helpmech.
In This Article...
SERPRESULT
0 * Clockwise starter rotation Permanent Magnet Gear Reduction (PMGR) Family * Mounting Shims
Shop online and pick up free at your neighborhood O’Reilly Auto Parts to find the best Starter for your 2009 Hyundai Sonata.
How much does a starter replacement for a 2009 Hyundai Sonata cost?
Hyundai Sonata starter replacement typically costs between $397 and $517. The cost of labor is expected to be between $86 and $109, while the cost of parts is between $311 and $409.
Why won’t my Hyundai Sonata start?
(ski boots, high heels, etc.) may prevent you from using the brake and
1. Keep the smart key with you or leave it in the car.
2. Ensure that the parking brake is set securely.
3. Position the shift lever in P (Park).
4. Press down on the brakes.
5. Depress the button to start/stop the engine.
6. After the vehicle hasn’t been washed or in exceptionally cold weather (below – 18°C or 0°F).
operated for a number of days without hitting the accelerator, allowing the engine to warm up.
setting the lever to P (Park). You may put if the flow of traffic and the state of the roads allow
When the car is still moving, place the shift lever in the N(Neutral) position and
- Though the vehicle is far from you, even if the smart key is inside of it,
- If any door opens when the engine start/stop button is in the ACC or ON position
Children should not touch the engine start/stop button or any other vehicle controls.
- If the smart key is malfunctioning or the battery is poor,
- You cannot start the engine normally if the stop lamp fuse is blown.
- The engine start/stop button shouldn’t be pressed for longer than five seconds unless
- Press the smart key button to release it from the holder.
Turn the key inward and pull it out. If you forcefully remove the smart key without first doing so
On a Hyundai Elantra from 2009, where is the starter?
The Hyundai Elantra’s starter is situated beneath the engine. When you turn on the ignition key, this strong tiny motor starts the engine.
How much does a 2009 Hyundai starter cost?
For your 2009 Hyundai Sonata, we now offer 17 Starter items, with prices ranging from $126.99 to $377.99 in our inventory.
How much does a Hyundai Sonata starter replacement cost?
The normal price range for a starter replacement is $440 to $551. Between $112 and $141 can be spent on labor, while between $307 and $410 can be spent on parts.
How much does a 2013 Hyundai Accent starter cost?
For your 2013 Hyundai Accent, we now offer 8 Starter items, with prices ranging from $129.99 to $349.86 in our inventory.
How much does a Hyundai Accent starter cost?
A new Hyundai Accent starter typically costs between $363 and $518. Between $83 and $105 is the expected cost of labor, while between $279 and $413 is the projected cost of parts.
Why did a Hyundai Sonata turn off while it was moving?
Transmission malfunction: The torque converter, which replaces the manual clutch in a car with an automatic transmission, is in charge of transferring power. The converter won’t function properly if the torque converter is damaged or if the transmission fluid level is low; as a result, the vehicle won’t be able to sustain power at low speeds, which results in the engine cutting out. This problem can also be brought on by a broken torque converter solenoid or TCS.
The fuel pump is in charge of moving fuel from the tank to the engine regardless of low fuel pressure, filthy or damaged fuel injectors, or a faulty fuel pump. Low fuel pressure from a damaged fuel pump can lead to an uneven stream of fuel being delivered to the engine. This doesn’t matter as much at high speeds, but at low speeds, even a little interruption in the fuel delivery might cause the engine to stall. A precise amount of fuel is sprayed out by the fuel injectors, and at the right moment, it is ignited by the spark plugs. Over time, injectors can get clogged or unclean, which causes irregular spray or no spray at all.
Bad oxygen sensor or mass flow sensor: The oxygen sensors and mass flow sensor let the vehicle adjust the air-to-fuel ratio by detecting how much oxygen is entering the fuel stream. Your vehicle won’t run as efficiently if the oxygen level is too high or too low. The car will continue to run at driving speeds, just like with low fuel pressure, but this insufficient power won’t be able to fuel the vehicle when it slows down.
Wires that are loose or rusted in the wiring harness: An ignition that fires inconsistently will cause an easily stalled engine. The vehicle can quickly lose voltage and won’t have the power it needs to remain running when you slow down if the wires are not in steady, dependable, and consistent contact with the ignition circuit.
Idle air control actuator malfunction: During idling, the engine’s RPMs are controlled by the idle air control actuator. The electronic control unit (ECU) sends information to this actuator, letting it know what RPM to keep the engine at for a secure and smooth idle. When the actuator is broken, the engine is not sent a signal for the idle speed and shuts off.
EGR valve obstruction or restriction: Depending on whether the EGR valve is jammed open or closed, a clogged, unclean, or damaged EGR valve might cause your automobile to stall, idle incorrectly, or sputter.
Is there a recall on my Hyundai Sonata?
Certain Santa Fe and Sonata models from the model years 2021–2022, which feature 2.5L turbocharged engines, are being recalled by Hyundai Motor America (Hyundai). The pipe connection between the high-pressure fuel pump and fuel rail may leak fuel.
What room is the starter in?
If your vehicle has rear-wheel drive, the starter is often located on the passenger side of the engine, directly below the exhaust manifold. If it is a front-wheel-drive vehicle, look above the transmission on the driver’s side or under the exhaust manifold. On some automobiles, they may also be found just beneath the intake manifold. If you open the hood to discover that your starter is covered in engine oil, a malfunctioning starter may really be a sign of an oil leak. Keep an eye out for oil leaks to prevent starter problems of this sort because, regrettably, what begins as a few droplets of oil can steadily and often unnoticeably evolve into a costly problem.
Can a car with a bad starter be jumpstarted?
Recently, my starter has been extremely erratic, so I’m wondering if a jump start would help fix the problem. Can I jump start my car if the starter is bad?
In less than two minutes, find out if your auto insurance is being overcharged.
Although a car with a defective starter can be jump started, the underlying problem will not be resolved. Your car’s battery, not the starter, is what a jump start is for.
While a jump start can help the starter acquire the extra power it needs to start your engine because the starter is powered by the battery through a relay, it is not certain that a jump start will be helpful if the problem is with the starter.
To get the problem correctly identified and resolved, you are best off visiting a mechanic. Jumping your car every morning is not a workable approach, regardless of the circumstance!
A reliable strategy to make sure you’re taking good care of your set of wheels is to take it to the mechanic, along with giving it a robust vehicle insurance coverage.
In less than a minute, Jerry will produce comparable quotes from leading providers if you’re looking for auto insurance.
What does a starter cost at AutoZone?
Cost of a Starter Replacement. Starting at $50 up to $350, rebuilding parts for a starter can be expensive. A new starter might cost anything between $80 and $350. You should budget $150 to over $1,100 for a skilled mechanic to replace or rebuild your starter.
What transpires when a car’s starter fails?
It frequently makes a grinding noise when the starter drive gear is worn out or not engaging properly. This sounds a lot like the sound you make when you unintentionally turn the ignition switch back on after starting your car. The engine flywheel could be harmed if the grinding symptom is ignored.
I don’t want to remove my starter, but how can I test it?
The engine must be spun or cranked by the starter. If it does, the wires, connectors, or relay are the cause of the issue. If not, start the engine and use the black/negative jumper cable to establish a connection between the drivetrain and the battery’s negative terminal as a ground. Connect the red cable to the positive starter terminal.
Can I change a starter on my own?
The majority of people believe that if their automobile won’t start, the battery is to blame. They attempt to boost it, but it still won’t turn on. Obviously, it’s a beginner or something little more severe. The alternator receives a charge from the battery of the car through the starter. The alternator’s charge makes it possible for the car to start. The car is dead if the starter is worn out since it won’t accept or send a charge. A repaired starter is just as effective as a new one and is less expensive than buying a new one, which is pretty pricey [source: Allen]. Save money by replacing the starter yourself if it is the true source of the issue. How to change an automobile starter is as follows:
- In order to disconnect the negative battery cable from the battery, turn off the ignition.
- From the starter, unplug the positive cable—the substantial cable that connects to the battery.
- Using a ratchet, unplug each of the bolts holding the starter to the block.
- Any additional mounting brackets keeping the starter in place should be removed.
- The starter’s bolts must all be removed. Bolts that are difficult to remove or extremely tight should not be forced. Instead, use oil or lubricant to aid in removing the bolt.
- Take the starter out of the vehicle.
- The new starter should be mounted on the block and fastened with bolts. Reconnect the battery cable to the starter before tightening the bolts.
How can I tell if my starter is defective?
- #1: The Engine Won’t Start.
- #2: Loud, grinding, or whirring noise.
- #3: Occasional Trouble Starting the Car.
- #4: The Starter Continues After the Start.
- #5: Smoke.
- #6: The starter engages but the engine won’t turn over.
- Seven: Battery