The failing ABS or brake assist system is indicated by the ABS warning light.
In This Article...
Headlight indicator (U.S.A.)
informs you that the headlights, taillights, instrument panel lights, parking lights, license plate lights, and side marker lights are all on.
Low fuel level warning light
Alerts you to when the fuel level is low. For more detailed information on how much petrol is left in your Toyota, consult the owner’s manual.
Maintenance required reminder
At our Toyota dealership in Morrow, many of the new Toyota models we have available for sale are equipped with a maintenance-required reminder light to make sure you perform the needed maintenance.
Security indicator
When the ENGINE START STOP switch is turned off in a car equipped with a smart key system, the light flashes to indicate that the system is working. The light will flash on Toyota vehicles without a Smart Key System once the key is taken out of the ignition.
Slip indicator
The slip indicator will light up when your car starts to lose traction and slide. You will be informed that the VSC/TRAC systems are operational via this.
SRS airbag on-off indicator
You can tell if the passenger air bag is on or off by looking at the AIRBAG ON and AIRBAG OFF light, which lights. To properly activate or deactivate the airbag, this device senses the conditions of the front passenger seat.
TRAC OFF Indicator & VSC Off Indicator
informs you whether TRAC and/or VSC have been turned off. TRAC and BSC can reduce engine output to the wheels if your Toyota becomes stuck in fresh snow or mud. When the system is turned off, you might be able to liberate the car by rocking it back and forth. For information on how to disable this function in your individual model, contact our Toyota service team.
How do I turn off the SRS light?
The airbag light connects the seat belt system and the airbag system as part of the Supplement Restraint System (SRS) in automobiles (and vice-versa). When you turn on your automobile, the airbag light comes on for around seven seconds before going out, signifying that the internal system check was successful and finished. When the airbag light either never turns on or stays on while blinking, an issue exists. The airbag light needs to be reset at this stage.
Examining seat belt components, fixing bad clock springs, and replacing faulty sensors are a few techniques for turning off an airbag light. New bulbs or a fully charged battery are other options. While most repairs can be done without a professional, others may.
The following 10 steps will reset your airbag light:
- Turn on and off your ignition.
- Test drive your car when it has been restarted.
- Check the airbag switch for the passenger.
- Check to see if the seat belts are in place and functioning properly.
- Check to see if the passenger seat sensor is off.
- Use a scanner with the ability to reset the SRS or airbag light.
- Fix the broken airbag sensors.
- Replace or repair a broken clock spring.
- Check to see if the airbag is working properly.
- seek for a specialist’s help.
Although not exhaustive, the list above includes tried-and-true methods for tackling the problem. Some of them might not apply to your vehicle because compatibility is always based on the year, make, and model. It is recommended that you have your service manual on hand when carrying out any of these fixes. Always follow the manufacturer’s recommendations, too. Let’s get started on resetting your airbag light right away.
What could turn on the SRS light?
The SRS light might illuminate for a variety of reasons. Utilizing a diagnostic scan tool is the simplest way to identify any SRS or airbag system issues.
The SRS light’s most frequent reasons are listed below:
Seat Belt Latch Failure
Sensors in the SRS keep track of when the seat belts are buckled. The connection may be hampered if anything has gotten within the buckle.
Remove any foreign things from the seat belt buckle to solve the issue. Spray some compressed air into the buckle if you don’t see anything.
Defective Passenger Seat Occupancy Sensor
If someone is sitting in the front seat, there is a sensor that informs the SRS system. It reads weight in addition to alerting the sensor when someone is nearby.
The passenger airbag will be ready to protect the occupant if there is an adult in the seat. However, if the sensor is malfunctioning, the SRS light may turn on.
Corrosion
Corrosion within your vehicle due to water damage can develop quickly. This might be disastrous if it happens among the SRS parts. It may not only result in the warning light turning on, but it may also have an impact on how well the system works.
Corrosion must be extensively inspected in all of the components if this issue is to be resolved. Everything that has been impacted must be replaced.
Bad Clockspring
The steering wheel contains this electrical connector. Its major job is to keep the SRS computer and the wheel connected when the wheel is rotating.
However, a lot of hate is frequently directed towards this section. The driver’s side airbag might not inflate in an accident if it stops operating. The SRS light will also give you a warning to let you know what is going on.
Dead SRS Computer Battery Backup
In order to store the data it receives, the SRS computer needs a backup battery. When the engine is off, the battery still functions.
The SRS light may turn on if the battery is running low or dead. The installation of a new battery is the sole solution to this problem.
Previous Accident
After an accident, if the airbags did not deploy, your SRS light can turn on. The system was most likely activated during a collision by the crash sensors.
But if something went wrong and your airbags failed, a fault signal would be transmitted to the computer. As a result, the computer needs to be reset, as indicated by the SRS light.
Faulty SRS Computer
All electrical parts degrade with time. The SRS computer is susceptible to failure just like any other computer. Its demise may be caused by heat, severe vibration, aging, and water damage.
The only fix for a dead computer that causes the SRS light to illuminate is a replacement.
Drive while the SRS light is on?
One should not ignore the airbag light or the SRS warning when they appear. It doesn’t necessary imply that the vehicle is unsafe to operate, but doing so is risky and akin to playing with fire. When this light is on, it indicates that your safety system isn’t functioning properly and, in some situations, that your airbags aren’t functional and won’t deploy in a collision.
Can I drive safely with my SRS light on? The answer is negative, as there is a significant risk if an accident were to occur, even if it is possible that the airbags may still deploy with the light on. We advise having a specialist examine it and identify the problem so that it may be corrected right away.
What does it cost to repair the airbag light?
The type of defect that needs to be fixed will determine how much it will cost. You might shell out between $1,100 and $1,500 to repair the airbag in the steering wheel, mostly for the labor. But if you can fix the clock spring yourself, it should only cost $250 to $350 to replace it.
Between $350 and $450 is the typical cost to repair an airbag sensor, with the parts typically costing approximately $300. If you don’t have a sophisticated code scanner, it’s advisable to have a mechanic handle the repair because the codes will need to be reset.
Can the airbag light self-reset?
It’s time to discover how to reset the airbag light now that we understand how airbags work. If you are not completely confident in your abilities, have only professionals operate on the airbag system. To reset the airbag light, adhere to these instructions:
Step 1: Check the passenger airbag switch
There is a “passenger seat Airbag on/off button” in some autos. When attempting to remove the airbag light, you ought to start by doing this. It’s possible that someone turned it to Off by accident before you, which will cause the airbag light to remain on in most cars. If you open the passenger door or glove box, you might be able to view this button, which is often located on the passenger side of the dashboard.
Step 2: Read the trouble codes with an OBD2 Scanner
Working with your airbag system is essential, therefore always use an OBD2 scanner to read the fault codes to determine where to begin troubleshooting. Never resolve the issue brought on by the airbag light before clearing the trouble codes. Continue the diagnostic by reading the codes to learn what might be the issue’s cause.
Step 3: Repair the fault
Never simply reset the airbag light without fixing the issue. When a collision occurs, this may cause the airbags to deploy or not work at all. If you are unsure of how to repair the airbag’s parts, let a pro handle it. Always remember to disconnect the battery connection before servicing an airbag. After fixing the issue, the airbag light frequently goes away by itself, although not in all car types.
Step 4: Clear the trouble codes
It’s time to reset the engine light when you have completely installed the new parts and are confident that everything is installed correctly. There is no other way to accomplish this; you must use an OBD2 scanner. Make that the airbag light is reset and that it no longer appears on the dashboard. If the problem persists, read the codes again and look for any error codes.
Step 5: Restart your car & test-drive.
Restart your engine and take a test drive if your dashboard’s airbag light appears to have disappeared. After a test drive, if the airbag light has disappeared, there is a good likelihood that the issue has been resolved. Reread the codes and carry out the steps again if the issue reappears.
SRS malfunction: what is it?
Have you ever seen a “SRS” light flash on your dashboard? Few Mercedes owners are aware of what this light signifies. Actually, its full name is Supplement Restraint System. This applies to things like airbags and your safety belts. Your airbags might not deploy in an accident if your SRS is malfunctioning. You can see why; it’s crucial to make sure these things are in good operating order!
- the most recent diagnostic technology
- master certified technicians for Mercedes-Benz
- a three-year, 36,000-mile warranty
- car on loan with extensive repairs
Our staff members are genuine Mercedes enthusiasts, and they will handle your car as if it were their own. Come and enjoy European auto repair with a personal touch, we cordially invite you.