Toyota Highlanders come with a tire pressure warning system that flashes an alert on the instrument panel whenever one of the tires’ pressure levels drop. Only when pressure is severely low, as determined by the sensors, will the low-pressure sign appear. When new tires are installed, the system needs to be reset so that the sensors can re-calibrate. The system must be reset in order to rotate the tires.
In This Article...
How can the tire pressure light on a Toyota Highlander be turned off?
Resetting the Tire Pressure Light on a Toyota Turn the key to the “On position when the car is off, but don’t let it run. When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset.
How can you turn a 2008 Toyota Highlander’s tire pressure light back on?
1) As stated on the tire and loading information label, set the tires to the prescribed (cold) pressures. 2) Switch the ignition on. 3) When the tire pressure warning light blinks three times, press and hold the tire pressure warning reset switch for at least three seconds (one second on, one second off).
Why, Toyota, does my tire pressure light remain on even after filling the tires?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.
The TPMS reset button is where?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
Why does the TPMS light continue to illuminate?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
Do 2007 Toyota Highlanders come equipped with TPMS sensors?
All American-made automobiles must have direct or indirect TPMS systems fitted as of 2008 as a result of the TREAD Act’s 2007 mandate.
The Toyota Highlander has a direct TPMS system fitted, which means the wheel has TPMS sensors. In the event that one or more tires on a Direct TPMS vehicle show low tire pressure, the TPMS sensors will communicate this information to the car’s ECU. Each tire pressure or an indicator light (low-line TPMS system) will be displayed on the dashboard (high-line TPMS system).
After a sensor change or tire rotation, a TPMS relearn is advised. A TPMS relearn is necessary to transmit sensor data to the vehicle’s ECU when services, such as tire changes or TPMS sensor replacements, are carried out on one or more tires of a Toyota Highlander.
How can I turn off the tire pressure warning light?
How to Clear the Tire Pressure Indicator
- Don’t start the car; just turn the key to “on.”
- While the car is off, disconnect the positive battery cable.
- All tires, including the spare, should be 3 PSI overinflated before being entirely deflated.
- Bring your car to our service department for qualified help.
My tires are in good condition, so why is my low tire pressure sign on?
Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.
How much time does a TPMS reset take?
Turn the key to the “on” position with the car off, but don’t let it run. When the Toyota tire pressure sensor blinks three times, hold down the TPMS reset button until it stops blinking. Start the car, then let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
In what location is the TPMS sensor?
In the US, direct TPMS usage is more prevalent. The sensors are either housed in the tire pressure valve, which also serves as an antenna, or they are band-clamped to the wheel rim. These gadgets deliver the data to an on-board computer.
Driving with the TPMS light on is it safe?
There are several possible meanings when you see that silly little light with the exclamation point glaring back at you. It’s frequently anything as harmless as temperature changes that result in a change in the tire’s air pressure. In more severe situations, a puncture or other damage has caused the tire to lose pressure. The sensor can also be activated and result in the light coming on if your tires are overinflated.
Is It Safe To Drive With TPMS Light On?
To avoid seeming like Debbie Downer, we’ll simply say no. Driving around with your TPMS light on is not safe. You can’t tell how quickly your tire is losing air or how long it has been over- or underinflated without doing a tire examination. The best course of action is to check the current inflation level of each tire with a tire pressure gauge.
When the tire inspection light appears while you are driving, slow down and get to the closest gas station or service facility.
Will the TPMS light turn on if my tires are over-inflated?
You most likely have a Tire Pressure Monitoring System (TPMS) installed if you drive a more recent vehicle. Your tires’ internal electrical TPMS system keeps track of their air pressure. The TPMS turns on a dashboard warning light if your tires are either under- or over-inflated. You need to have your tire pressure checked if the light is steady. You should have your TPMS examined if the light is flashing.
Visit one of our stores for a free tire pressure check if you notice the TPMS light. If you’re on the road, fill up your tires with air as soon as you can at a petrol station. unsure how much more to say? For further information, see How to Check Tire Air Pressure.
Don’t panic if the TPMS light illuminates or flashes after you install the spare if you need to change a tire. Nothing to worry about there; that’s merely the system’s way of letting you know it can’t locate a TPMS unit in the spare tire.
Accurate tire pressure is now possible thanks to TPMS. It automatically alerts you when the pressure is low, keeping you safer, preventing damage to your tires, and increasing your MPG.