Turn the key to the “On position when the car is off, but don’t let it run. When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset.
In This Article...
On a 2013 Toyota Camry, how do you turn off the tire pressure light?
Start the ignition, but don’t let the vehicle go. Then, open the glove box. A reset button is located on the left side. Then hold down the reset button while waiting for the TPMS light to slowly flash three times. Reset the device, then turn it off.
On a Toyota Camry 2021, how do you reset the tire pressure light?
Make sure your tires are properly inflated before attempting to reset your Toyota’s TPMS. The reset button is typically located low and to the right of the steering wheel. Next, start your engine. The TPMS indicator light will then gently blink three times while you continue to depress the button.
Why, Toyota, does my tire pressure light remain on even after filling the tires?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.
The TPMS reset button is where?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
My tires are in good condition, so why is my low tire pressure sign on?
Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
How long before the tire pressure light appears?
After a few kilometers of driving, the light may turn off if the tires are adequately inflated. After around 10 miles, if the light still remains on, it may be necessary to reset the TPMS as instructed in the owner’s handbook of the car.
How much time does a TPMS reset take?
Turn the key to the “on” position with the car off, but don’t let it run. When the Toyota tire pressure sensor blinks three times, hold down the TPMS reset button until it stops blinking. Start the car, then let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button.
On a 2010 Toyota Camry, where is the TPMS reset button located?
Open the glove box to reveal a reset button that is tucked away beneath a little lip to the left of the glove box. Hold down the button until the TPMS light gently blinks three times.
In what location is the TPMS sensor?
In the US, direct TPMS usage is more prevalent. The sensors are either housed in the tire pressure valve, which also serves as an antenna, or they are band-clamped to the wheel rim. These gadgets deliver the data to an on-board computer.
Why will my tire light not turn on?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
When the tire pressure light is on, can I drive?
You should be able to find our store or an air pump if the light just came on and you need to get there. However, it is unsafe to keep driving while the light is on. This is why: When you drive your car with low tire pressure, you accelerate the premature and severe tire wear.