In This Article...
Identify the TPMS system type.
Resetting the tire pressure sensors on a 2009 Toyota Yaris hatchback with a direct system might only need pressing a reset button on the dash or navigating a menu as described in your owner’s manual. If the 2009 Toyota Yaris hatchback has an indirect system, it must be reset by a dealer or one you have personally purchased using a magnet or scanning tool. In order to reset some systems, the ignition must be turned on while the reset button is pressed and held down for three seconds within the glove box.
Pump up the tires.
Ensure that all tires are inflated appropriately. All tires must be fully inflated because you are resetting the sensors to “zero,” or else the sensors won’t be properly calibrated and their readings will be off.
Evaluate the battery.
If the sensor in your 2009 Toyota Yaris hatchback is powered by a battery, make sure it is not dead. The battery should be changed every five years. Since the battery is integrated, in certain cases this necessitates replacing the complete sensor unit.
Make the transponders new.
Every wheel has a unique transponder. Each responder’s location changes when the wheels are rotated, and the TPMS needs to learn their new locations. Although this relearning process varies depending on the vehicle, you can get more information in the TPMS chart in your manual or online. If the valve stems double as tire pressure sensors, it is a good idea to swap them out when purchasing new tires.
Apply the magnet technique.
Press the lock and unlock buttons on the key fob when the key is in the ignition but the engine is not running. Placing a magnet over each valve stem after the initial chirp will cause the horn to chip for each valve in the following order: left front, right front, right rear, and left rear. Make that the driver information center is showing the pressure values.
Utilize the scan tool approach.
The owner’s manual’s TPMS Reprogramming Procedure menu prompts can be followed if no sensors are being replaced.
TPMS reset button, closed loop
A “SET” or “TPMS RESET button can be found on some Toyota vehicles and is either under the glove box or beneath the steering wheel. The system searches for the already-stored sensor IDs when the button is pressed. The “SET button can be utilized while replacing tires, changing or altering tire pressure, changing tire size, or conducting a tire rotation with differing tire pressures in the front and back.
The ECU must be unlocked in order for the relearn method to function properly if the “SET button is pushed after new sensor IDs are introduced but before a relearn is carried out. A few sophisticated TPMS diagnostic tools can unlock the ECU. You can successfully complete the relearn procedure if your TPMS scan tool offers the “UNLOCK ECU option.”
The Toyota Yaris, Yaris iA service screen may be seen in the image, which comes from the ATEQ VT56 TPMS tool.
Direct vs. Indirect TPMS systems
Before beginning any repairs on a Toyota Yaris, “CHECK TPM” should be carried out. The tool will be able to show if the car was made with a direct or indirect system using the VT56 or VT46 brands.
- Choose GOLF and VOLKSWAGEN (brand of vehicle) (vehicle model)
- CHECK TPM can be found on the main menu.
- The tool will reveal whether the car is an indirect system from the YEAR menu.
When changing air pressure, rotating tires, or replacing a TPMS sensor, an indirect relearn should be carried out if the vehicle has an indirect system, which means there are no sensors in the wheel.
Where is the Toyota Yaris’ TPMS reset button?
When the Toyota tire pressure sensor blinks three times, hold down the TPMS reset button until it stops blinking. Start the car, then let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button.
On a 2009 Toyota Corolla, how do you reset the low tire pressure indicator?
Resetting the Tire Pressure Light on a Toyota Turn the key to the “On position when the car is off, but don’t let it run. When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset.
Where is the button to reset my TPMS?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
Why won’t the tire pressure warning light come on?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.
Why, after filling the tires, is the tire pressure light still on?
If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.
Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.
My tires are in good condition, so why is my low tire pressure sign on?
Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
On a 2009 Toyota Camry, how do you reset the low tire pressure indicator?
Open the glove box to reveal a reset button that is tucked away beneath a little lip to the left of the glove box. Hold down the button until the TPMS light gently blinks three times.
TPMS on a 2009 Toyota Corolla?
The tire pressure monitoring system warning light will illuminate if your TPMS sensor has stopped working or its battery has run out. Count on the professionals at your local Toyota service center to complete any required repairs on your 2009 Toyota Corolla.
Where are TPMS installed?
In the US, direct TPMS usage is more prevalent. The sensors are either housed in the tire pressure valve, which also serves as an antenna, or they are band-clamped to the wheel rim. These gadgets deliver the data to an on-board computer.
Will the tire pressure light automatically turn off?
After a few kilometers of driving, the light may turn off if the tires are adequately inflated. After around 10 miles, if the light still remains on, it may be necessary to reset the TPMS as instructed in the owner’s handbook of the car.
How soon does the tire pressure warning light turn on?
Even when the tires are in good shape, the low tire pressure light may occasionally remain on. In such circumstances, you should manually check the tire pressure to make sure there is no issue. People frequently witness this light in the coldest part of the day, the morning. However, the light occasionally turns off when the temperature rises. In any case, until the air warms up and expands, your tires may still be a few PSI under-inflated in cool weather.
A defective tire pressure sensor often exhibits three symptoms. When you discover that your tires are flat but the sensor didn’t alert you, it is the first scenario. The second sign that anything is wrong with the sensors is when your ECU turns on the TPMS light on your dashboard. When the sensor suggests that you have a flat tire when you are aware that you don’t, it is the third indication of an inaccurate alert.
After a few kilometers of driving with properly inflated tires, the sensor light typically turns off. However, you should reset the TPMS in accordance with the directions in the owner’s manual if it doesn’t turn off automatically after traveling for around 10 miles.
In 2008, the U.S. Department of Transportation mandated that tire pressure monitoring systems be installed in all automobiles (TPMS). As a result, even if you can reset it, the TPMS in your car cannot be turned off.
Technically, driving with the TPMS light on is possible, but it is not recommended. The sensor alert indicates either an under- or over-inflated tire. Ignoring this warning could result in excessive tire wear or possibly a blowout, all of which could be dangerous for you and other road users.
Does Toyota alert you to a low tire?
Tire Pressure Monitoring Systems are standard on all new Toyota vehicles (TPMS). Essentially, the system’s function is to inform drivers when a tire or tires are in need of being refilled, repaired, or replaced. Any queries customers may have about the TPMS in their Toyota car can be addressed by the service team here at Toyota Palo Alto. Come see how the Tire Pressure Monitoring System in Your Toyota Vehicle operates with our team today!
What Should You Do When the Tire Pressure Monitoring System Warning Light is Active?
In order to measure the tire pressure for each of the car’s four tires, the Tire Pressure Monitoring System in your Toyota vehicle essentially uses sensors. The TPMS Warning Light and a warning message will both illuminate on your Toyota instrument panel when one or more of your tires have too little air in them. Now, drivers should check the pressure in each of their four tires, and if required, fill them. If, after doing so, the warning light and message still appear, you should contact your neighborhood mechanic or a Toyota dealership to have the problem further investigated.
How Do You Reset the Tire Pressure Monitoring System?
Sometimes the alert will also appear after you rotate your tires, change your tire size, or adjust the tire pressure. In these situations, all you have to do is reset the TPMS to account for the modifications you made to your car’s tires. Simply press and hold the while the engine is running to reset the TPMS “Most Toyota models include a reset button on the instrument panel to the right of the steering wheel. Keep the “Press the reset button three times until the TPMS Warning Light blinks slowly. To finish the reset procedure, let the engine run for a few more minutes and then shut it off again.
Visit us at Toyota Palo Alto right away if this procedure doesn’t work if you think your Toyota vehicle’s TPMS is seriously malfunctioning. Visit us as well to learn more about the service deals we have to offer!