After every oil change, the Toyota Highlander 20092010 needs to have its Oil Change Light Reset. The device won’t be able to accurately track when your next oil change is necessary if it is not reset.
The steps for the Toyota Highlander 20092010 are listed below. After every oil change, reset the oil life monitor by following the instructions below.
In This Article...
Non Hybrid
- Turn the ignition key to the “RUN position or press the “ENGINE START STOP button once.
- Verify the trip meter “A is shown; deactivate the ignition.
- Press the “ENGINE START STOP button once or flip the ignition key to the “RUN position while still holding the trip meter reset button.
- Hold the button down while waiting until “A 000000 is shown.
- Switch off the ignition.
Hybrid
- Once, press the “POWER button.
- Switch off the hybrid system while tripmeter “A” is visible.
- Press the “POWER button once to turn on the power while holding the trip meter reset knob.
- The word “COMPLETE” will be seen.
Oil Viscosity and Capacity
When the engine oil and filter are changed, the 2.7 liter engine can contain roughly 5 quarts (4.7 liters) of 0W-20 oil.
When the engine oil and filter are changed, the 3.3 liter engine carries roughly 5 quarts (4.7 liters) of 0W-20 oil.
When the engine oil and filter are changed, the 3.5 liter engine carries roughly 6.4 quarts (6.1 liters) of 5W-30 oil.
Not Working?
Make sure you are following each step precisely and in the sequence shown in the Oil Change Light Reset Oil Change Light Reset Toyota Highlander 2009 2010 procedure above if the oil change light reset technique is not successfully resetting your oil life monitor. Restart your oil light reset method check HERE if this is not how to reset your vehicle’s oil life monitor.
How can you turn a Toyota Highlander’s oil change light back on?
Toyota Highlander Maintenance Light Reset Press the odometer button on your dashboard quickly, hold it there while turning the key to the second position. Hold the odometer button down for another 10 seconds or so. You can hear a beeping noise in addition to the maintenance light beginning to flash. The light ought should thereafter go out.
On a 2009 Toyota RAV4, how can you reset the maintenance is required light?
How to Turn Off the Maintenance Light on a RAV4
- Put your key in the ignition of the RAV4.
- On the dashboard, press and hold the trip meter reset button.
- For ten seconds, keep pressing the odometer button.
- Release the odometer button after the light is off, then start the vehicle.
How can I turn off my Toyota’s maintenance light?
Turn the key to position two while pressing and holding the odometer button on the dashboard. When the maintenance light begins to flash, keep holding the odometer button. There may even be beeping sounds. The light ought to dim.
What does the triangle in a Toyota Highlander with the exclamation point mean?
Have you ever been operating your Toyota Highlander when a symbol suddenly appeared on the dashboard? If so, then every sign has a unique meaning. Everybody occasionally gets a visit from a dashboard light.
While some lights are only indicators, others are alarms indicating your Highlander requires regular upkeep or repairs. It’s crucial to understand what each dashboard light on your vehicle indicates.
An indication light is any light that appears on the Toyota Highlander’s dashboard and is either blue or green. A light that alerts you that anything in your car is on is what an indicator light does exactly as it sounds. The majority of the time, it indicates on your dashboard whether a Highlander feature has been activated or canceled.
Some of the typical warning lights that you might see are listed below:
- Headlight High Beam Indicator: This blue light signifies the active state of the headlight high beams.
- The VSC/TRAC OFF Indicator shows whether the traction control or vehicle stability control systems are activated or off. To turn off the light, push and hold the switch while the car is still moving.
- Turn Signal Indicator: These green lights signify that the Highlander’s right or left turn signal has been engaged.
- An icon resembling a speedometer serves as a visual cue that the cruise control system is engaged.
- An emblem in the shape of a key will display on your Toyota Highlander’s dashboard to let you know that the security system is operating as intended.
- TRAC OFF Indicator: This light appears to alert you to the need to turn off the vehicle’s traction control and/or stability control systems.
Your Toyota Highlander will have a warning light if it has a yellow or red light. A warning light is typically an issue that needs to be resolved right away in order to keep your SUV in the finest condition possible. If you notice any of the lights listed below, get in touch with our service staff to arrange a visit:
- When an icon resembling an old-fashioned oil can appears, it means your oil pressure is too low and should be checked. Low Engine Oil Pressure Warning Light: You should take immediate action to address this problem in order to prevent potential engine damage.
- Master Warning Light: When the master warning system detects a problem, a triangle with an exclamation point inside of it shows on the dashboard and a buzzer sounds.
- Electric Power Steering (EPS) Warning Light: It’s critical to have your Highlander evaluated if this warning light, which looks like a steering wheel next to an exclamation point, comes on your dashboard.
How can you turn a Toyota’s oil light back on?
In order to start the car, turn the ignition to position one after inserting your key. Turn your key to position two after pressing and holding the trip meter reset button on the dashboard. Hold the odometer button down for a further ten seconds. The light should then begin to flash and potentially beep before turning off.
Why does my car keep telling me to replace the oil when I recently did?
If your oil light continues to illuminate even after changing the oil in your engine, you should examine the sensor to rule out a faulty sensor as the root of the problem. The oil pump might become clogged with dirt and other debris, leading the sensor to mistakenly report oil problems. Although changing the sensor is pretty straightforward, you should take your car to a qualified mechanic if you don’t feel confident doing it yourself. Low oil pressure is the following typical reason. Your oil light will turn on if the oil pressure drops below 5 pounds per square inch. You should check the oil level even though this shouldn’t happen after an oil change because you never know.
Even after an oil change, the final common cause of a lit oil light is perhaps the most troublesome. Numerous engine problems might result from the oil pump not circulating enough oil to maintain the engine’s parts lubricated and operating as intended. Parts do wear down over time, even though getting oil changes at regular intervals should prevent this issue from happening.
I just changed my oil, so why is my change oil light on?
Let’s move on to the car’s second oil light, the oil pressure light. When this light turns on, it indicates that the engine’s oil pressure has fallen, and you need to act right away. The engine of your car can suffer severe harm if you keep the light on while driving.
The light signifies that something is interfering with the engine’s ability to receive a continuous flow of oil from the oil pump to lubricate its components when it is operating normally. You can consider oil to be the vital component of your car’s engine. Your engine is protected from heat and friction with the right oil level. But without it, your engine can sustain damage quickly. Therefore, it’s crucial to routinely check your oil and filter. You must deal with it if the light comes on. Here is what to do.
- Next, locate the engine compartment of your car (often by lifting the hood) and check the oil level.
- To do this, take out the dipstick, clean it with a rag, then put it back in the engine and pull it out again to check the level. The oil level is low if it is below the “full line.” (If you are having difficulties locating the dipstick, refer to your owner manual.)
- If the dipstick does really show low oil, look for any indications that your car is leaking. A failing gasket or seal may be the cause of oil dripping. If there isn’t an obvious outward oil leak, the engine may have an interior issue.
- Turn off your engine and first pull your car securely to the side of the road.
Purchase the proper oil for your car’s kind and weight, then refuel the engine until the dipstick reads “full.” If the light remains on even after you restart your car, get a professional opinion by calling for a tow truck.
Does oil life reset on its own?
How to Reset: As part of the servicing, authorized Honda dealers will automatically reset your Maintenance Minder System. However, you must manually reset the oil life indicator if you execute the oil change yourself or have it done someplace else.
What does the Toyota Highlander’s maintenance required light mean?
Simply put, the flashing maintenance required light is alerting you that maintenance on your car is necessary. The indicator will come on when a predetermined period of time has passed since your car’s last service or based on how far you’ve driven it.
This light typically indicates that you should change the oil in your car. The maintenance data will be reset for you when your car has been taken in for service.
To manually reset the system to turn off the light, however, follow these instructions:
When the maintenance light comes on, you can continue to drive, but bear in mind that you are doing so at your own risk if the required or scheduled repair is skipped.
My maintenance is necessary light is on, why?
The mileage is the only factor that activates the maintenance required light, also known as the service required light. When this light turns on, different automakers have varying standards. For instance, the maintenance needed light on a car might turn on once every 10,000 lights and stay lit until it is manually turned off.
The oil change, spark plug replacement, new tire, etc. are just a few examples of the routine maintenance that should be performed on a vehicle.
When servicing your vehicle, mechanics typically reset the maintenance required light. The process for resetting the maintenance required light differs based on the make and type of the car, yet, if they don’t, you can do it yourself.
What does it imply if your Toyota has a maintenance required light on?
On your dashboard, the Toyota maintenance light may read “MAINT REQD. It’s a light that is always on and alerts you when you require an oil change at a licensed auto shop. Your Toyota will run more smoothly and efficiently if you change the oil in your car.
How long is a maintenance light good for?
The oil light suddenly came on. You’re clueless as to why. And to make matters worse, you don’t really have a lot of time right now to worry about it.
How long can you drive with this object is in your face, you ponder. wonderful question We’ll respond to it and explain why it could have initially surfaced. Move along!
How Long Can You Drive With Oil Light On?
If the oil light comes on, you should try to get a repair to look at your car as soon as possible. However, keep in mind that a little more driving around won’t harm anything.
Typically, it takes about two weeks or 500 miles of driving before a flashing oil light becomes a serious issue. However, once that happens, things can quickly deteriorate and cause significant mechanical damage. Therefore, attempt to get your car serviced as soon as possible.
There’s Not Enough Oil in the Car
Numerous issues, including blown head gaskets and broken valves, can cause engines to leak oil. Whatever the case, if oil leaks from your car, it will begin to suffer and may eventually sustain catastrophic damage. As a result, the oil light will turn on when there isn’t enough oil in the vehicle.
The Vehicle’s Oil Pressure Is Low
A vehicle needs enough oil pressure to operate at peak performance. However, keep in mind that a number of things (such as an obstructed oil filter, a broken pressure gauge, insufficient engine oil, etc.) could cause the oil pressure to go too low. This will cause the oil light to come on.
The Oil Pressure Sensor is Malfunctioning
The malfunction of your oil pressure sensor may also cause your oil light to come on. Randomly, this happens, usually as a result of normal wear and tear. If the problem is not corrected, your car won’t have enough oil pressure, which will eventually cause more harm.
The Oil Pump Is Bad
A car’s oil pump may eventually fail as a result of wear and tear on the vehicle. The oil light will unquestionably respond to this. The only option at that point would be to replace the pump since if you don’t, your engine would experience increased friction and end its life much earlier than it should.
Is Your Oil Light Still On?
We have a group of expert vehicle repair specialists who will locate the cause of your check engine light before taking steps to fix it.