Your 2007 Toyota Corolla’s airbag is an essential safety feature. The airbag warning light will turn on if the airbag is malfunctioning. You must have your airbag serviced by a qualified mechanic if this light comes on. After the issue has been resolved, your airbag light can still be on. This light needs to be reset. If you don’t, the SRS system won’t be able to warn you when something goes wrong in the future.
In This Article...
Step 5
Unbend a paperclip, then touch one end to one terminal on the connector and the other end to the opposite end of the terminal to jump the two electrical terminals. The two terminals will leap as a result, and the SRS light on your dash will stay on for 10 seconds. Then the light will go out.
Close the fuse panel cover by putting it back over the fuse panel until the retaining clips snap, securing it in place, then reconnect the SRS electrical connector for the airbag to the fuse panel.
- Toyota; 2007; “Toyota Corolla 2002-2007 Service Repair Manual”
- Paperclip
With six years of experience in the financial services sector, I am a Registered Financial Consultant. I have received training in financial planning, with a focus on annuities and life insurance. Since 2009, I have been a writer for Demand Studios.
How is the airbag on a Toyota Corolla reset?
When you experience the same problem, you should start by following this technique, which is identical to resetting the airbag light on a Toyota Camry. It needs timing the airbag light and has four straightforward stages that are simple to complete.
First, activate the ignition. Wait for the airbag light to turn on next; it typically illuminates for seven seconds before turning off automatically. After waiting three seconds, immediately flip the ignition switch off. Before starting the engine, go through the basic procedures a couple of times. Your car’s airbag light should illuminate for seven seconds before turning off permanently if everything is done correctly.
Why is my Toyota Corolla’s airbag light on?
A little person wearing a seat belt and having a circle in front of his face represents an airbag warning. We’re getting off topic, but we believe the circle represents an airbag in artistic form. Your new Toyota Camry or Corolla’s airbag light turning on indicates that your on-board diagnostics system has detected that the airbags might not deploy in the case of a collision. Although it is not a guarantee, it is not worthwhile to test them.
Can the airbag light be reset without a tool?
Without a scanner, most automobile models make it difficult to reset the airbag light. This is a safety warning since, when the airbag light appeared, you should always fix the problem. Fortunately, if you fix the issue, the airbag light will typically also turn off by itself in many automobile models.
However, in some older vehicles, the airbag light can be reset without a scanner by disconnecting the battery wires.
Make that there are no loose wires or rust in the connector plugs in the wiring system under the driver’s or passenger’s seat. Restart your car after spraying an electronic cleaner on the connecting plugs.
If you can’t detect any issues there, you should really invest in an OBD2 scanner or have a shop interpret the codes because otherwise you’ll have to guess what the issue is.
What is the cost of turning the airbag light back on?
Reset Airbag Light, at No. 1 This procedure typically takes several hours and costs a few hundred dollars, though depending on the car, it might cost as much as $600.
What may make the airbag light continue to illuminate?
A problem with the seatbelts or airbags is indicated by the airbag light. Therefore, it’s usually not a good idea to drive when the airbag light is on. We advise having it towed to the dealership rather than driving it yourself if it continues to flash inside your car.
Can a blown fuse turn on the airbag light?
The car could have blown a fuse, for example. There are other fuses that could be to blame, but fuse #13 is most likely the one. You probably need to change fuse #13 and perhaps other fuses if your airbag light is on and your rear windshield wiper is not working. The airbag light can undoubtedly turn on as a result of blown fuses.
The airbag light may also abruptly turn on in a number of other situations. A mechanic or auto parts store should be able to decipher the code that the airbag system emits when it is acting up, which will give them a hint as to what specific issue the airbag is experiencing. There are numerous potential issues with the airbag because it is a complicated system of sensors, wiring, and programming that must suddenly activate during an accident after lying dormant for years. Check the fuse box to see whether you have a blown fuse first, but if not, you’ll likely need to take it to the dealer or a qualified mechanic for service.
Why does the airbag light turn on?
The airbag light will be on if your airbag has been deployed and has not been correctly reset. When the system detects that it cannot trigger the airbag, the light will turn on if the airbag hasn’t been deployed. This indicates that there is an issue with the airbag system in your car.
When my airbag light is on, can I drive?
The airbag light may have illuminated for any number of reasons, just like other warning lights. Here are a few of the most frequent causes:
The airbag needs resetting
The airbag light will turn on if there has been a collision but it wasn’t serious enough for the airbags to deploy. At your neighborhood garage, the airbag needs to be reset.
Corroded sensors
The sensors in your automobile may have deteriorated if it has water damage. This would lead to a malfunction in the system and turn on the airbag light.
Dislodged wiring
If your car has side airbags, the passenger side airbag may occasionally malfunction. When the passenger seat is shifted back and forth, the wires for that airbag may become damaged or displaced. We caution against attempting to reconnect a detached plug because you risk setting off the airbag. Make an appointment for your car at a nearby garage and ask them to check it.
Faulty seat belt
Your seat belt sensor can be the cause of the problem. The sensor that determines whether or not you have buckled up can malfunction occasionally. When this occurs, the airbag light can start to illuminate.
Your airbag clock spring may need replacing
The spring is intended to preserve continuity between the wiring and the driver’s airbag and coils throughout your steering wheel. The spring may wear out and fail over time, turning on the airbag warning light. Older autos are more likely to have this flaw.
The important line is that you must stop driving as soon as your airbag light illuminates and have your automobile inspected by a repair as soon as possible. Your airbags won’t activate until the issue is identified and remedied. Never disregard your airbag light since your safety and the safety of your passengers are top priorities.
What location does the airbag module have?
A mechanism that manages the airbag system is known as an airbag control module. A car has a number of airbags, some of which are at the front, on the sides, or knee-level to the occupants. A automobile only has one SRS airbag module unit, though. Depending on the make and model of the car, the airbag module can be found in different places. It may be found in the center console, kick panel, under the radio, or behind the steering wheel in some automobiles. However, it is typically located underneath the driver’s or front passenger’s seat. Instead of airbag control modules, heavy-duty vehicles like buses and trucks utilize engine control modules. On the front passenger side of the car, these devices are frequently found beneath the glove box on the instrument panel.
It is impossible to overstate the significance of an airbag module. It enables the full airbag system to function. When there is a sudden halt or accident, the airbag module collects data from the impact sensor and sends a signal to the airbags to deploy. The airbags of a car wouldn’t even inflate without a working airbag module. The airbag sensor is locked following airbag deployment and remains so until it is changed or entirely reprogrammed.
After a collision, the rigid codes and crash data saved in the airbag module can be quite helpful and are typically admissible in court. This compact device stores data on seat belt use, engine and vehicle speed, throttle position, impact speed change, airbag deployments, and seat belt pre-tensioner deployments. More helpful than other physical evidence or verbal explanations, the information from the airbag module is frequently examined by those who study auto accidents.
What is the price of an airbag sensor?
Depending on the automobile model and labor charges, the cost to replace an airbag sensor ranges from $100 to $600. A sensor for an airbag costs between $50 and $300, as does the labor.
Both the airbag sensor and its replacement are delicate parts. Even for an expert, correctly diagnosing and installing the airbag sensor can take up to two hours.
The airbag sensor itself is typically not very expensive; you may anticipate paying between $50 and $300 for a brand-new one. Never purchase aftermarket sensors; don’t take the chance. Always purchase OEM original, authentic items.
You can save money by replacing the airbag sensor yourself if you are highly confident working on cars and meticulously following the repair manual.
If you have even the least qualms regarding the replacement, have a pro handle it.
Keep in mind that it is a crucial component, therefore installing it properly is important in case of an accident. Additionally, if you make a mistake, there is a chance that all of the airbags in the car will deploy, which will cost thousands of dollars to fix.
Driving without airbags is possible.
Is it prohibited to operate a vehicle without an airbag? Does this go against any laws?
Driving a car or any other motor vehicle without an airbag is now banned under neither state nor federal law, making it comparable to doing so while towing a trailer or wearing a sling on one arm.
Although it is not specifically prohibited to drive without airbags, it is not allowed to modify or remove airbags from certain automobiles.
Vehicles without airbags were still offered by manufacturers in the 1990s. However, when airbags were accepted as a standard safety feature in 1999, everything changed. The laws governing this safety device have now been revised.