Your Sienna’s tail light bulbs will eventually stop working due to regular use’s persistent wear and tear. However, a water leak near the tail light assembly has the potential to cause damage and most frequently does. A dry-rotted seal around the assembly may cause this. Additionally, dirt contamination might result from cracks or holes in the taillight lens. You can fix the broken tail lights on a Toyota Sienna at home with a few simple tools. You shouldn’t need more than an hour to finish the repair.
In This Article...
Step 1
Turn on the taillights on your Sienna and move to the back of the car. Decide which tail light bulb needs to be replaced before turning the power back off. On the interior driver’s side, underneath the dashboard, pull the hood release lever.
Step 2
Lift the hood, then use a socket wrench to unplug the battery’s black cable. The negative cable is the one that is black. On top of the battery, there should also be a minus symbol (-) next to it.
Step 3
Lift and securely support the rear lift gate. Two tiny bolts ought to be visible on the inside side of the tail light assembly. Use the socket wrench to remove them both.
Step 6
Holding the flawed bulb between three fingers, gently remove it. Straight out of the socket, remove the bulb. Put on some rubber gloves and take the replacement bulb out of its packing.
Step 7
On the metal contacts at the base of the lightbulb, apply a very thin bead of dielectric grease. If the grease touches the glass, throw away the bulb and replace it with a new one. Reinstall the new bulb in the socket and give it a gentle push to secure it.
Step 8
Put the socket back in the tail light assembly where it belongs. Turn the socket a quarter turn clockwise to secure it in position. The tail light assembly should be installed the opposite way it was taken off. Take your socket wrench back and tighten the two bolts holding the tail light assembly together. Reclose the lift gate.
Using your socket wrench, reattach and fasten the black cable to the battery. To check the repair, close the hood and restart the electricity to the tail lights.
How is the tail light assembly changed?
Replacing a Tail Light
- Step 1: Open the tailgate or trunk.
- Step 2: Remove the tail lamp assembly (if needed)
- Step 3: Remove the bulb.
- Step 4: Insert a replacement bulb after adding bulb grease.
- Step 5: Reattach the component (if needed)
- Repeat step 6 on the opposite side.
How much does a new tail light assembly cost?
Cost of replacing a tail light Expect to pay between $200 and $500 if you elect to have a professional replace your tail light assembly. If you own a high-end luxury or performance vehicle, the cost of the job may increase.
How challenging is a tail light component replacement?
Fortunately, changing the tail light bulbs isn’t hard and shouldn’t take you more than 45 minutes to an hour. Be careful that newer models could be a little trickier to disassemble than older ones because there will be more wires.
Tail Light Assembly
The group of lights positioned on the back of your car is known as the tail light assembly. They are made up of the reverse lights, brake lights, and tail lights. Each set of lights has a specific function for nighttime conspicuity. The red tail lights are connected to switch on in conjunction with the activation of the front position lighting. When the driver applies the brakes, the brake lights turn on. On both sides of the car, these lights, which are a vivid red, are mounted in multiples of two.
In some vehicles, the brake lights and the tail lights can be merged. They can be placed as a dual-intensity bulb in these circumstances, with the brake-light having a brighter intensity. Fog lights are also used in cars to improve rear sight in heavily foggy conditions. When the driver shifts into reverse to back up the automobile, the reversing lamps turn on. For both your safety and the protection of other drivers, you must make sure the tail lights are in functioning order.
You should replace the tail light assembly if your tail lights have sustained external damage or if the lenses are dim. For every make and model of vehicle, Buy Auto Parts keeps a large selection of tail light assemblies in stock.
We offer excellent aftermarket components as well as original OEM replacements. All of our auto components are rigorously examined and backed by a warranty. Choose the correct year, make, and model of your car from our online catalog to view the components that fit it. You can purchase premium tail light assemblies at Buy Auto Parts for unbeatable pricing, plus free shipping. Contact us by email at [email protected] or over the phone at 1-888-907-7225 if you have any inquiries about our auto parts.
How is a tail light assembly taken out?
Safety Advice
Always use safety eyewear when performing maintenance on your car. When necessary, put on additional personal protective equipment (PPE), such as latex gloves or closed-toe shoes.
On the back of your car, find the tail light assembly. When you use your brakes or turn signal, they illuminate on each corner.
Remove any mounting screws that are present on the exterior of the tail light assembly, if necessary.
When my taillight breaks, can I still drive?
Don’t be shocked if you are pulled over if your taillight is damaged. A broken taillight is one of the safety offenses that police are constantly looking out for. It makes it more difficult for people to see you, and if the second one burns out as well, it will be quite difficult for approaching drivers to see you at night from the back. However, you won’t necessarily receive a penalty just because you’re stopped for a faulty taillight. Although it is technically against the law to drive with a broken taillight, most police officers would likely only issue you a warning and instruct you to have it replaced as soon as possible. However, some police officers do issue citations for damaged taillights.
O’Reilly modifies the tail lights?
While you wait, at no cost to you, our parts specialists can swiftly and easily change wiper blades because they are experts at changing headlamp and taillight bulbs.
Can AutoZone repair damaged tail lights?
Shop online or visit your neighborhood AutoZone for nearby tail light lens repair. Having a practical fix for cracked, chipped, or damaged tail lights is crucial for both emergency situations and regular car maintenance in your garage.
Can a lens from a broken taillight be repaired?
Even if you have the time, replacing taillights can be time-consuming. The speed and ease of the tail light repair depends on the amount of work required. There is no alternative, however, if you are able to do so, than changing the taillights. Any chips and cracks can be repaired.
Does the entire tail light need to be replaced?
If one of your taillights has failed, you should have it changed as quickly as you can in order to ensure your safety as well as to avoid getting stopped. Finding the precise bulb that has burned out is occasionally the most difficult aspect of replacement. Normally, there are three on each side. To be able to check all the bulbs, you’ll probably need to turn on your engine. Here are the following three actions:
- Clean up any corrosion with a rag or brush before replacing the bulb. As you push and turn to replace a “twisting bulb, ensure sure the tabs are aligned correctly.
- Turn off the engine as soon as you identify the offending bulb. See your owner’s handbook for details on how to remove the bulb. Vehicles come in a variety. You’ll see fasteners on some that allow access from the outside, while panels that require entry via the trunk must be removed. Some automobiles demand that you unplug the electrical cord and remove the entire taillight housing component.
- Some bulbs need to be gently twisted to the left while being pulled back. Others demand that you pull the bulb out of the base directly. Remember to refer to your manual once more.
In conclusion, it’s not always as simple as it first seems to change a bulb in your taillight. Bring your automobile to Lake Arbor Auto if you run into problems! Our professionals can discuss with you the unique characteristics of some bulbs and other finer points of this frequent issue.
AutoZone does it replace brake lights?
Problems with the brake light switch or turn signals A replacement switch can be placed after you check the connection to the switch for corrosion or other problems and buy it at your neighborhood AutoZone.
Are the brake light and the tail light interchangeable?
Many automobiles have a single globe that houses both the braking and tail lights. In other words, both lights have the same external covering. Your car’s may be a little different, with individual globes. In contrast to brake lights, which turn on instantly when you hit the brakes, tail lights are activated by turning on your headlights or applying the parking brake. The brake lights are a brighter red than the tail lights, which are typically red on cars. White back-up lights are also included in your rear lights.