You’re probably right because key fob batteries need to be changed occasionally. To replace the battery in a Toyota RAV4 key, simply carry out the following steps:
- Note the locations of the positive and negative ends when you remove the old battery from its housing.
- Put a fresh CR2016 battery in place of the old one.
- Carefully peel apart the two pieces of the plastic key component with a flathead screwdriver.
- Take the module out of the key.
- Close the key with a snap and check the remote’s functionality.
- With the flathead screwdriver or the edge of a coin, carefully pry the module open.
- Replace the module into the key after snapping it shut.
Why not spend a little more time with Jerry discussing your insurance options while you’re learning more about your car key?
Jerry is a free insurance comparison app that shops around for the best deals with more than 50 different insurance providers. You may make adjustments at any time, receive prices instantly, and text an agent with any queries you may have.
In This Article...
What kind of battery is needed for a 2017 Toyota Rav4 key fob?
A CR2032 battery is typically available at big box stores and hardware stores in Watsonville. Most places have prices that are under $5. Replace the Toyota key fob batteries, then put it in the case and snap the key fob shut.
How long does the battery in a Toyota key fob last?
When your Toyota key fob’s battery is running lowthe typical battery life is one to two yearsan alert will sound when the engine is turned off.
What size battery does a key fob for a 2015 RAV4 require?
How to change the battery in the Toyota RAV4’s “Tombstone key fob” (2013, 2014, 2015, 2016, 2017, 2018, 2019) For a step-by-step demonstration on how to replace the battery in your key fob, see the video below. You will require a single CR2032 battery.
How is the battery in a 2011 RAV4 key fob changed?
Although a broken key fob is typically not a reason for alarm, it is nonetheless annoying. Most key fob batteries have a lifespan of three to four years, so if you haven’t changed it in that time, that’s definitely the problem.
Follow these easy steps to replace the battery in a 2011 Toyota RAV4 key fob:
- After that, carefully remove the battery using a pen tip (or another similarly thin device) while being careful not to damage the tabs holding it in place.
- The middle housing for the circuitry ought to release.
- After reassembling the housing, attach the key fob as a whole. Test it lastly.
- Pry apart the battery housing after removing the circuitry housing.
- The key fob can be separated from the top with a butter knife or another thin implement.
- Put a new CR2016 battery in place of the old one. The majority of these batteries are sold in $2 to $3 two-packs.
You might need to change your key fob if this doesn’t resolve the problem. This key fob will probably be inexpensive since it is an older model. Typically, one costs between $35 and $50.
Why not spend a little more time using the Jerry app to use the few minutes you already spent replacing the battery in your RAV4 key fob to save hundreds of dollars on your auto insurance?
Jerry assists you in finding and comparing rates from more than 50 leading suppliers in minutes as a licensed broker. Jerry can assist you with purchasing new coverage and even canceling your existing policy when you discover a lower cost for your 2011 Toyota RAV4.
Which battery should I use in my 2018 Rav4 key fob?
Pull the tab containing your emergency (manual) key and depress the button on the side of your Smart Key. If your Smart Key’s battery dies, you can still unlock the vehicle using this method. The Smart Key case may be broken in half with the emergency key once the manual key has been removed, revealing the battery. The battery will pop out if you pull down on the tab keeping it in. Snap the Smart Key back together after replacing it with a fresh CR1632 battery (some models use a CR2032 battery).
My Toyota key fob uses what kind of battery?
A CR2032 battery, which you can get in shops and online, is used by the majority of Toyota models. These batteries are really inexpensive, usually costing less than $5. Replace the battery in your Toyota key fob within the casing, then cap it off.
If the battery in my key dies, would my car stop?
This issue has been foreseen by automakers ever since the key fob was created. Nothing will happen if your key fob dies while you’re driving. Simply because the key fob is a locking and starting device only, the automobile will continue to run. The key fob has no influence over the ignition or engine once the automobile is moving.
Even though you’ll need to go to a general store or pharmacy to get the battery, replacing the battery in your key fob simply takes a few minutes if you’re pressed for time.
Why not take the time to renew your auto insurance at the same time as you’re replacing the batteries in your key fob?
You can access a new quotation with just a few taps on your phone screen by downloading the Jerry app and answering a few questions.
Jerry assists you in finding and comparing rates from more than 50 leading suppliers in minutes as a licensed broker. Jerry can assist you with purchasing new insurance and even canceling your existing policy when you find a lower rate.
Can a dead key fob battery still start a car?
- Use the mechanical key to unlock the door after you get it. If your door doesn’t have a key slot, it’s likely concealed beneath the handle cover. To access the key slot, carefully remove the handle cover by using the key.
- On your key fob’s back, search for a little sliding button. You can slide the key fob cover off or click a button to do so. To get it to release, you might need to use your fingernail and a little force.
Now that you’re inside, here’s how to start the car with a dead key fob:
- Check the steering column for a physical key slot if neither of these approaches succeeds (some Mazda models have this feature). To start the car, place the mechanical key within the keyhole.
- Press the START button with the key fob. Instead than pressing the button with your finger as usual, push the key fob against it. Many manufacturers utilize this backup device to make sure the car can start even if the key fob is dead.
- Some vehicles have a secret key fob slot that can be used to start the engine. For instance, the backup slot is located inside the cup holder in some Ford models. Your fob will fit perfectly in the slot. Use the push button start as usual after inserting the dead key fob into the holder.
- Close the key fob after inserting the mechanical key once more.
If I change the battery, do I need to reprogram my key fob?
A remote key fob needs to be specifically matched with your car in order to be secure; otherwise, someone with a car of the same make and model as yours could use their remote to unlock yours. You’ll need to reprogram the fob if changing the batteries has erased this connection or if it was somehow disrupted in order for it to once again recognize your automobile.
Standard programming sequence
Your key fob can typically be reconfigured by following this typical procedure:
Instead of starting and then returning to the locked position, turn the key into the run position. Repeat this multiple times.
You’ll typically hear a chime or other sound when you’ve cycled the key enough times. At that point, you can push the lock or unlock button on your key fob to hear another chime.
What should I do if the battery in my Toyota key is low?
How to Replace the Battery in a Toyota Key Fob.
- Take the key out of the fob. Over the key portion of your key fob is a tiny metal button.
- Unlock the fob.
- Dispense with the green circuit board.
- Switch out the battery.
- Place the key inside the fob after putting the fob back together.
What should you do if the battery in your key dies?
The Family Handyman claims that you can still start your car even if the battery in your key fob dies. Put the metal key back in the fob after using it to unlock your doors; then, instead of pressing the “start” button with your finger, use the fob. Many manufacturers utilize this backup device to make sure the car can start even if the key fob is dead.
Now, the Mini has a slot where the key fob can be inserted to start the vehicle. But at this time, this design seems a touch dated. This is why it’s always a good idea to consult your car’s manual.
Some Mazdas and a few other vehicles may have an actual key slot along the steering column, according to the Family Handyman. The least frequent method to start a car with a dead key fob is this, though.
How long will a key fob with low batteries operate?
Whether a key fob has a low battery depends on whether it is a smart key fob or a conventional fob. A normal key fob with a low battery can last up to 4 to 6 years, whereas a smart key fob with a low battery can last for up to 2 to 3 years.