swivel the light
Insert a new # 2825 light bulb after removing the old one from the socket.
You can also use a suitable LED unit or any other small wedge-base bulb, such as the #168, W5W, or 194.
What kind of screwdriver is required to replace a license plate?
Some people may think that changing their license plate screws is a difficult operation, but with the appropriate information, it is actually pretty simple. You can purchase a license plate thumb from a dealer to assist you screw in your license plates.
However, before starting to change your license plate screws, you need have a screwdriver on hand that will allow you to unscrew the old ones and screw in the new ones. It can be a flathead or a Phillips head screwdriver.
You can replace the screws holding the license plate to your front or rear bumpers by following the instructions below.
- The license plate’s frame should be removed and set away.
- You should clear the area around the holes of any dirt and debris.
- Put the license plate and its frame back in place where you took them off.
- After that, move to where the front license plate is and repeat the process of removing the old screws and adding new ones. So simple are new license plate screws to install.
- To make sure they are fastened, gently pull the plate.
- Start with the license plate at the back.
- Unscrew the two old license plate screws using a Phillips or flathead screwdriver. Two screws should be placed above the edge of the license plate.
- With the aid of a screwdriver, insert the screws into the holes on the plate and the frame, then start tightening the new screws until they are securely fastened.
How is a license plate light installed?
A license plate light installation guide:
- Buy new license plate lights as the first step.
- Step 2: Take off the housing cover for the license plate using a flat screwdriver.
- Step 3: Carefully remove the bulb housing, then unscrew the original bulb.
- Step 4: Replace the old LED light with the new one and screw it firmly into the housing.