You should only need to remove the bumper cover if you are merely replacing the stock bumper on your Toyota Corolla with an aftermarket or customized model. You must take off the cover and bumper beam if the bumper has been harmed in a collision in order to replace it. If the bumper has sustained significant damage, modify the removal process as necessary to account for the affected areas.
In This Article...
Preparing the Car
The Corolla’s front end should be raised and supported on jack stands in order to thoroughly access the bumper; make sure the parking brake is engaged. The air bag system interacts with the bumper, so you must turn it off. To do this, totally detach the batteries from the vehicle by unplugging both the negative and positive cables. A minimum of two minutes should pass after disconnecting. Disconnect the fog lights’ electrical connectors, which are found on the rear of the bumper fascia, if your Corolla has them.
Bumper Cover
The bumper is attached to the top, bottom, and sides. You must take off the fender well liner and the ten mounting fasteners that hold the bumper cover in place in each fender well. With a little screwdriver, pry up the center button on the plastic fasteners, but leave the center buttons in the ferrules; do not remove them. There are two fasteners at the corners and two fasteners close to the centre of the bottom edge. To access the bottom bolts, remove the engine splash panels from underneath the bumper cover. The top of the bumper cover is held in place by the same screws used to hold the grille in place. Remove the grille by removing the screws on either side of it. Before you lift and pull the bumper cover off the automobile, be sure all of the fasteners have been taken out. Lifting off should require at least two persons.
Bumper Beam
The major element for absorbing an impact is the bumper beam, which is situated behind the bumper cover. The four mounting nuts on the beam’s four corners must be taken off in order to remove the beam. Remove the beam from its mountings. Similar to the bumper cover, this might require two persons. If the beam has been harmed in an impact, exercise caution because, if it hasn’t already, it might break apart.
How much does it cost to replace the front bumper on a Toyota Corolla?
Primered bumper covers normally cost between 74 and 319 USD, whereas raw replacements typically cost between 72 and 320 USD. However, when it comes to location, front bumper covers cost between 72 and 300 USD, while rear bumper covers cost between 74 and 319 USD.
Can I change a bumper on my own?
You can repair a damaged or rusty pickup bumper on your own. A bumper that is dented or rusted can ruin the overall appearance of a pickup truck that is otherwise in good condition. It will cost $1,000 to have it fixed professionally, but you can do it yourself and save $500 or more on labor and supplies. It only requires a few hours.
Is bumper replacement or repair more affordable?
Our qualified team members will examine your bumper when you bring your car to one of our repair facilities or pickup and drop-off locations to see if it needs to be repaired or replaced. Although more expensive, bumper repair may take longer to complete. Replacement of the bumper is quicker but more expensive. Continue reading for more information on bumper replacement and repair:
- Bumper Repair: Your automobile most likely only needs bumper repair if your bumper has minor dings, scrapes, or damage from running into a parked car. Bumper repair can be done in-shop and is frequently less expensive than replacing a bumper. Typically, bumper repairs cost between $100 and $1,000.
- Bumper Replacement: You most certainly need a new bumper if your current one has significant damage, such as cracks, missing pieces, deformities, or damage to any of the systems inside the bumper. Replacement bumpers are more expensive, and you will normally need to buy a new bumper from the maker of your car. Typically, bumper replacement expenses range from $800 to $2,000.
What is the turnaround time for a front bumper replacement?
I’m relieved to learn that there were no more significant consequences and that nobody was wounded. Unfortunately, depending on the severity of the damage and your mechanic’s schedule, the time it takes to fix a car bumper might vary significantly.
Your bumper could be repaired in as little as three hours if the damage is minor. However, you might have to wait three days for your bumper to be fixed if the damage is severe. Bring your car to an auto body shop to have the area assessed in order to determine the precise length of time the repair will take.
After receiving your price and time estimate, you may decide what to do next with greater knowledge. Whatever you decide to do, don’t forget to download the Jerry app to see how much money you may save on your auto insurance.
In less than a minute, Jerry will produce comparable quotes from leading providers if you’re looking for auto insurance. Jerry collects your data from your former insurance, so you won’t have to fill out any time-consuming forms or make any unnecessary phone calls. You receive complete savings and protection without any hassles.
How much does it cost to install a new bumper?
A replacement bumper for a passenger car can range in price from $100 to $1,000, according to Cost Helper. The price of installing and painting a new bumper can range from $200 to $600.
How is a bumper removed?
The best way to remove a dented bumper
- The dented bumper should be heated using a heat gun or a hair dryer. For at least 30 seconds or longer, warm the bumper.
- Point the nozzle of a compressed air can at the dent while holding the can so that the bottom is facing up.
- Hold off until the dent emerges.
How much does reattaching a front bumper cost?
Between $50 and $2,000 can be spent on front bumper repairs. The extent of the damage to your car’s bumper will determine whether you need a temporary patch or a complete replacement.
What do bumper clips mean?
A series of fasteners called a bumper quick release is used to affix a bumper cover to a car’s body. Your bumper cover should fit snugly against the body, just as it did when the automobile was made, thanks to its design. However, they also make it possible to swiftly take off the bumper cover.
Driving with a loose bumper is it safe?
Many accidents that are referred regarded as “fender benders” may actually be better described as “bumper benders.” The front and rear bumpers of your car play a crucial function in reducing the damage brought on by auto collisions, but they could do so at the expense of their own aesthetic appeal and structural soundness.
A little knowledge can go a long way toward assisting you in making the best decisions, whether you have just had bumper damage to your automobile or you simply want to know what to do in case of future bumper damage. Put yourself on the right track with the help of these frequently asked questions (and answers).
Although bumpers might lessen the overall impact forces caused by a collision, protecting occupants is not its main function. Instead, to prevent harm to you and your passengers, the car’s frame crumples in key places. Your car’s front or rear ends will sustain less damage thanks to the bumpers.
The bumpers available now combine minimal weight with shock absorption. While certain modified and vintage cars may have steel bumpers, most modern car bumpers are made primarily of plastic and supported by an inner steel or aluminum bar. This component mounts to a metal frame that is fastened to the outside of the car via hooks.
The bumper’s inside polymers may shield any major harm from happening in a minor collision. The paint may scrape, the plastic may fracture, or the paint of the other car may end up on your bumper from a passing hit. The bumper may split apart, damage, or crumple inward in more severe collisions.
The hooks that hold the bumper to your automobile can potentially be harmed by an impact. In this case, the bumper’s one end can droop awkwardly or drag on the floor. Your bumper assembly may just fall off if both hooks fail.
Your car won’t be as protected from harm by a damaged bumper as it normally would. Even while you might be able to drive with a broken bumper, the next collision could seriously damage vital parts. As a result, you might need to fix or replace some components of your grille, hood, or exhaust system.
A loose bumper provides a unique set of dangers. Even if the bumper hasn’t yet separated from the vehicle, further driving may cause vibrations that cause it to do so. If your bumper is damaged, it might hit another car or become caught underneath your own wheels, which might lead to you losing control of the car and possibly causing another collision.
Only superficial surface damage, such as scratches, may be repaired on a bumper. Many dents in vintage steel bumpers can be removed by hammering or pulling them out by your auto body shop professionals. Modern plastic bumper abnormalities can be fixed using a device called a nitrogen plastic welder.
Auto body professionals are skilled at swiftly and efficiently fixing bumper scuffs and scrapes. To produce a perfect end product, your car body professionals will clean and sand the area that has to be repaired before applying filler and paint.
However, if the repair is complicated, you might be forced to replace the bumper entirely. Anytime the metal support beam or hooks have received permanent damage, this circumstance may arise. If your bumper has a broken airbag, lighting system, parking aid, or blind-spot monitoring system, you might also require a complete repair.
What is the name of the plastic component under the front bumper?
When a car collides with a curb, speed bump, or another object, the bumpers are made to soften the blow. It may be quite expensive to repair or replace them if they are damaged.
For this reason, some automakers affix a plastic stripalso known as an air dam or front lower valanceto the bottom of the bumper on their vehicles. However, because plastic is brittle, these plastic strips are equally prone to breakage. Therefore, once the bumper’s plastic strip cracks, the bumper is exposed and more prone to sustain damage.
Fortunately, you can replace the plastic strip with something more durable. Here are a few possibilities: