Turn the key back to the “On position after finding the “trip reset button once more. Hold the trip reset button down until your odometer lights 0 miles. The maintenance light will thereafter go out.
In This Article...
On a 2010 Toyota Corolla, how do you turn the maintenance light back on?
Press the odometer button on your dashboard quickly, hold it there while turning the key to the second position. Hold the odometer button down for around 10 seconds. A buzzer sound and the maintenance light should start to flash. The light ought should thereafter go out.
How do I reset the needed maintenance?
How do I turn the “Maint Reqd” light back on?
- Switch the ignition to the ON position.
- Set the trip display to TRIP A mode on the odometer.
- Activate the OFF position on the ignition switch.
- Turn the ignition switch to the ON position while pressing and holding the Trip Meter RESET button.
- It will do so via the service maintenance reminder light.
Why does the maintenance required message on my 2017 Toyota Corolla?
On your dashboard, the Toyota maintenance light may read “MAINT REQD. It’s a light that is always on and alerts you when you require an oil change at a licensed auto shop. Your Toyota will run more smoothly and efficiently if you change the oil in your car.
Why, after an oil change, is my maintenance required light still on?
If your oil light continues to illuminate even after changing the oil in your engine, you should examine the sensor to rule out a faulty sensor as the root of the problem. The oil pump might become clogged with dirt and other debris, leading the sensor to mistakenly report oil problems. Although changing the sensor is pretty straightforward, you should take your car to a qualified mechanic if you don’t feel confident doing it yourself. Low oil pressure is the following typical reason. Your oil light will turn on if the oil pressure drops below 5 pounds per square inch. You should check the oil level even though this shouldn’t happen after an oil change because you never know.
Even after an oil change, the final common cause of a lit oil light is perhaps the most troublesome. Numerous engine problems might result from the oil pump not circulating enough oil to maintain the engine’s parts lubricated and operating as intended. Parts do wear down over time, even though getting oil changes at regular intervals should prevent this issue from happening.
Why does the maintenance required message on my Toyota Corolla?
- Verify that the odometer’s (ODO) total mileage displaytypically the ‘A’ displayis on.
- If the car is on, turn it off.
- Press and hold the ODO reset / readout button while the engine is off.
- Turn the key in the ignition while maintaining pressure on the ODO button. till the dash lights turn on. Avoid starting the car.
- The ODO display will briefly flash before beginning to display only zeros.
- Release the ODO button once it starts to show zeros, then flip the key back to the “off” position.
- Now the light will read “MAINT REQD.”
What ‘MAINT REQD’ Means
Within 5000 miles of the last reset, the “MAINT REQD” indicator illuminates. It is merely a mileage counter meant to serve as a reminder to the user that an oil change is required and in no way indicates any system failure. If a specialist has always performed maintenance on your Toyota, they reset it after each oil change. It should be noted that the recommended oil change interval is not always 5000 miles. To find out how frequently the oil in your Camry needs to be changed, consult the owner’s manual and your usual technician.
Need Help?
Our service team would be delighted to assist you. Our entire staff of experts is Toyota-certified and adept in resolving even the most challenging problems with your Toyota. Make an appointment right away!
The maintenance light on my 2018 Toyota Corolla needs to be reset.
Put the maintenance light out.
Corolla, Toyota Activate the lock on the “OFF position; do not start the vehicle. the trip reset button next to the odometer is pressed and held until “On the main screen, Trip A may be shown. Reverse the key to “OFF. Turn the key back to the “on” position while pressing the button to reset the trip “position of ON.