- Fuse Box Under the Hood, Open.
- Activate the Red Terminal Cover.
- Connect the Toyota Terminal to the Red Jumper Cable.
- Red/Black Jumper Cables should be connected to the second vehicle.
- Your Toyota hybrid should have the black jumper cable connected to an unpainted metal surface.
In This Article...
How is a Toyota Highlander Hybrid jump-started in 2021?
No one is flawless, on that much we can all agree. Even though it might take a lot, your 2020 Toyota Highlander’s battery can nonetheless become discharged. A detailed instruction manual on how to jump start a 2020 Toyota Highlander has been produced.
Make sure you have a set of jumper wires and your key fob in your pocket before attempting to jumpstart your Highlander Hybrid.
Connect the positive jumper cable clamp to your car in the dedicated jump-starting connector. The second vehicle should then be connected to the other positive end. The negative on your vehicle’s end should be connected to a stationary, unpainted metallic point far from any moving parts, and the negative to the second vehicle.
Start the second vehicle’s engine after everything is connected, then raise the speed a little. For five minutes, keep the engine running at this pace to recharge your car.
It’s time to put your Toyota Highlander through its paces once the second car has been operating for five minutes. Before you do anything, double-check that all of your doors are closed. Once everything is in place, drive the second car at a constant speed while turning on the power. See if the “READY” indication illuminates.
Once your hybrid system has started, disconnect your jumper cables in the opposite sequence.
Make sure to get your Highlander Hybrid checked out if something still feels weird.
How can a Toyota hybrid jump start another vehicle?
- Avoid overusing your hybrid vehicle’s jumper cables on other vehicles as this can harm the electrical system.
- Turn off your headlights and inside lights, then engage your parking brake.
- Disconnect the hybrid system and take your key off.
- Fuse block cover, hood, and special jump-starting terminal cover should all be opened.
- The exclusive jump-starting terminal should receive the positive clamp (red) jumper cable.
- Connect the vehicle’s discharged battery’s negative clamp (black) to a stable, solid, unpainted metallic point.
- Make sure all unneeded lights are turned off and that the vehicles are not touching if the booster battery is put in another vehicle.
- When boosting a car, always utilize a battery that is the same or better in quality.
- Allow the jumper cables to be attached and the discharged battery to rest for five minutes. Then, with the gas pedal barely depressed, run the engine of the car that is boosting at roughly 2,000 RPM.
- Make sure the “ready light is on” before starting the hybrid system.
- After the negative cable, disconnect the positive cable.
Can you jump a Toyota hybrid?
Jump-starting a Prius or another Toyota hybrid is quite similar to jump-starting a gas-powered car. Jumper cables, a helping vehicle, and a solid metallic point are all required to jump a Prius.
The Toyota Venza has a starter, right?
Estimated cost to replace a Toyota Venza starter. Replacement starters for Toyota Venzas typically cost between $300 and $492. Between $65 and $81 is the expected cost of labor, and between $235 and $410 is the estimated cost of parts.
Can a hybrid be used as a jump starter?
The jump-start terminal of a 2010 Toyota Prius is visible in this picture. If you’re facing the front of the Prius, the terminal is on the right side of the vehicle and has a black cover that closes over it. Author: Allison Loudermilk
While dealing with a dead battery in a hybrid automobile is more difficult than dealing with one in a standard gasoline vehicle, the situation is probably not as severe as you might think. Why? The truth is that not all hybrid systems are made equal.
- Since the hybrid auto industry’s powertrains are not standardized, there is a lot of difference across brands and even within the same brand for model year redesigns.
- Many hybrid vehicles feature many batteries, some of which may not be in the typical places.
- If the battery dies, certain hybrid vehicles do require a trip to the dealer.
- Some modern hybrid vehicles have self-starting capabilities.
Any car you attempt to jump start is risky if you don’t know what you’re doing. Hybrids increase the procedure’s level of anxiety. Hybrid cars can typically be jump-started just like a regular automobile with a standard gas engine. It is true that not all conventional gasoline vehicles have the same powertrains, but learning how to jump-start a gas vehicle is simple because of this. However, the unique design of many hybrids’ powertrains can initially be perplexing.
The majority of hybrid models have two different batteries: a larger 12-volt battery used primarily for starting the car, which can be found under the hood but is frequently found in the trunk. This battery is smaller than the main high-voltage battery in the powertrain and is used when the car isn’t using its gasoline engine or runs in tandem with the gas engine for greater efficiency. Some people may feel it’s dangerous or difficult to jump-start a hybrid because of the existence of its high-voltage battery pack, but those batteries should be simple to distinguish from the smaller, more common 12-volt battery used to start the automobile (and thus, jump-starting). To avoid electric shocks from unintended contact, a hybrid battery pack should be enclosed and labeled with warnings. Make sure the battery you’re using is the right one with additional caution, and everything should go well.
Both of those batteries have the potential to run out of power, so if you’re experiencing battery issues, you’ll need to identify which battery is to blame. You’ll need a mechanic to look at the primary hybrid battery if your car won’t start and jump-starting doesn’t help.
The jump-start terminal found under the hood of many Toyota hybrid vehicles, including the Prius, should be used in place of the 12-volt battery. The procedures for jump-starting the hybrid are essentially the same as for jump-starting any other vehicle after you have found this terminal. (If you have a Toyota hybrid and are now stranded on the side of the road, this video about jumping a Toyota hybrid may be very helpful.)
Verify that you aren’t actually out of gas before presuming you need a jump start. According to Popular Mechanics, some hybrid vehicles, including the defunct Chevrolet Silverado and Nissan Altima models, shut off when the petrol tank is empty even when the battery is completely charged. Others, like those made by Toyota and Lexus, can only operate for a limited time (a few miles, tops), provided the primary battery is fully charged.
By the way, the smaller 12-volt battery is what you’ll need to utilize if you need to jumpstart another vehicle using a hybrid vehicle. The battery of a hybrid vehicle is typically found in the trunk as opposed to under the hood, and the terminals should be marked with plus (+) and negative (-) posts like the battery of a conventional vehicle. An example of this is the Toyota Prius. Check your owner’s manual if you can’t locate the battery in the trunk or if there aren’t any indicated terminals for jump-starting.
We’ve been cautious to say that “most” conventional cars have a 12-volt battery that serves as the starting mechanism up to this point. That’s because, according to Automobile & Driver, up until 2017, every modern car had a battery like that. The first contemporary mass-produced vehicle to defy the trend was the Hyundai Ioniq, which was then followed by the mechanically similar Kia Niro. Hyundai chose to use a lithium-ion battery in place of the 12-volt battery, and it is situated next to the primary hybrid battery. A switch inside the vehicle marked “12V Batt Reset” draws enough electricity from the main hybrid battery to jump start the starter battery in the event that the starter battery dies. In other words, while the Ioniq and Niro can jump-start themselves, they cannot be used to jump-start another vehicle or be classically jump-started. In addition to being more practical, the lithium-ion starter battery is 26 pounds (nearly 12 kilograms) lighter than a typical 12-volt starter battery, which improves the efficiency of these cars.
Your best bet if you drive a hybrid vehicle is to become familiar with the jump-starting options and techniques for your particular model before you need them. The owner’s manual for your vehicle is a reliable resource for this kind of knowledge. You can get in touch with the customer support team at the manufacturer or the service division at your dealership. Call a roadside assistance service if you are in an emergency situation and are unsure of what to do (AAA is 1-800-HELP). That will protect you from harm and assist prevent irreparable harm to the intricate powertrain of your hybrid vehicle.
The majority of new or certified used automobiles come with a roadside assistance contract, so keep that in mind if you find yourself in need of a jump but are unsure how to proceed. If you purchased an extended warranty for your car, you might also be protected. Last but not least, you can also add roadside assistance to your auto insurance.
Why wouldn’t a hybrid vehicle crank over?
Although the Toyota Prius is a dependable hybrid, anything can go wrong at any time such a complicated machine. While some of the problems can be identified and remedied at home, others could call for a trip to the technician and additional parts.
You may find some of the most typical situations that could prevent your Prius from starting below, along with instructions on how to fix them.
Overfilled Engine Oil
Overfilling the engine oil is a problem that is frequently ignored but actually occurs quite frequently.
Overfilling the oil can result in problems starting the car since the extra oil can enter the crankshaft or combustion chamber. Even though the oil capacity may range between Prius generations, the majority utilize less than 4 quarts. Consult your owner’s handbook to learn how to prevent overfilling. It ought to specify the amount and viscosity of oil to be used.
If you’re handy with cars, you may just drain a bit out using the same procedures you’d use if you were changing your own oil to remedy this situation. You might need to remove your intake manifold and clear out the oil from there depending on how much overfill you had.
Key Fob Battery
A weak battery in the key fob, which normally starts your automobile using a push-start button, may prevent it from starting. If you only have one key and aren’t currently changing the battery, consider placing it as close to the start button as you can. If you have a backup key, use it until you can get the first one to function once more.
Ignition Problems
One of the most frequent issues is a bad ignition. The engine won’t fire up if there isn’t a spark.
Spark plugs that are improper or defective are a typical reason. Even though the plugs themselves might not be the problem, system plug connections can loosen. If you feel comfortable doing it yourself, try tightening the spark plugs to fix the problem. Additionally, make sure that the proper spark plugs were not used after the manufacturer by consulting your manual to confirm which ones should be used.
Blown Fuse
Even though it’s uncommon, this is another item you can cross off the list when figuring out why your Prius won’t start. Make sure there are no blown fuses in the fusebox that could prevent the engine from starting. Keep in mind that the fuse box is an electrical component, therefore repairs should only be performed by a professional if you’re not sure how to manage any blown fuses.
Fuel Problems
Although filling the tank with petrol should be your first move if you are out of gas, we recommend checking other fuel-related issues as well.
Over time, dirt and other debris might clog your gasoline filter. The engine may not receive enough fuel pressure to start because of the dirty filter. A clogged gasoline filter needs to be changed because it cannot be cleaned.
Another potential offender is the gasoline pump. Your pump determines how much fuel the system needs, and if it’s broken, it might not be generating enough pressure. Most of the time, before this, your car would have displayed warning indications like jerkiness or intermittent breakdowns.
Issues With Security System
Extra security is incorporated into your Prius because it was designed with your protection in mind to deter thieves from stealing your car. When you attempt to start your automobile, a security alert will appear on the display if the security system is the issue. Simply making sure the key fob is close by will fix this.
Battery Issues
Battery troubles are another of the most prevalent problems. Given that your hybrid car has two batteries, it’s likely that one of them is to blame.
Since the 12v battery connections are the most straightforward to identify and fix, we’ll start there. Give them a thorough checkup to check for any rust symptoms that can make it difficult for them to transfer electricity from one location to another. If your battery is undamaged, corrosion can simply be cleaned off. It appears as white or green deposits.
A weak or dead battery could be to blame if the engine won’t start. In other cars, the 12 volt battery kicks the engine into gear, but in a Prius, it’s the hybrid battery. It’s best to always have a qualified mechanic who specializes in hybrids analyze and fix any difficulties with the hybrid battery because of its high voltage.
Overall, following all of the manufacturer’s maintenance advice is the greatest thing you can do to maintain your Prius in good condition. Every 5,000 miles or every six months, whichever comes first, Toyota advises scheduling maintenance.
The Toyota Prius is a dependable car, but routine maintenance will extend its lifespan and raise its value if you ever decide to sell.