When your Toyota key fob’s battery is running lowthe typical battery life is one to two yearsan alert will sound when the engine is turned off.
In This Article...
Can the battery in a Toyota key fob be changed?
This information can also be found in your owner’s manual; typically, Toyota key fobs need a CR 2032 3V. Most electronic retailers carry new batteries, or you may order one online. Place the key inside the fob after putting the fob back together.
Make Sure You’re in Park (parking mode)
Are you sure you’re in park? I know that sounds dumb and very, very common sense. If so, the automatic transmission in your car probably won’t let the key out unless you put it in park mode. The shift interlock, a safety mechanism, is to blame for this.
Wriggle Your Steering Wheel to Get the Locking Steering Column to Release the Key
Most cars have a locking steering column as an option. Once you take the key out of the ignition, it will lock up. That is intended to deter car thieves. If the locking steering column malfunctions, excessive pressure is applied to the ignition switch, which keeps the key in the Corolla locked.
You can get your key while your vehicle is in parking mode by turning the steering wheel.
Disconnect the Power to the Solenoid
Don’t worry if the aforementioned suggestions haven’t worked thus far. Sam Carmel, the proprietor of Corolla, claims in a “>YouTube video that the starter solenoid found in Corolla vehicles may hold the key (no pun intended) to resolving your problems. This solenoid activates the starter motor of the car by acting as an electromagnet. Two lengthy cables from the starter solenoid connect to the starter motor.
By cutting the wires, you should be able to turn off the solenoid. In the 2010 Corolla, at least, where Carmel focused for his film, the solenoid is located behind the steering wheel. He claims that modifying the solenoid is secure. Hopefully, that will produce the key.
Test Your Car Battery Life
Your Corolla can’t operate without power if the entire interior, including the ignition, is electronic. That usually means that if your automobile battery dies, your key could become seized. There are two clear signs that the problem is with the battery. Do you first notice any inside lights? Can you also start the car?
If the response to either of those two queries was no, your battery has likely died. If you’re not at home, you’ll need to acquire a jump. In order to avoid getting into another awkward situation, make sure you monitor your car battery in the future.
Confirm Your Ignition Lock Cylinder Is Properly Working
Your Corolla’s whole electronic system, including the ignition, cannot function without power. As a result, if your automobile battery occurs to expire, your key may seize. There are two clear signs that it’s a battery problem. Are there any inside lights visible, first? Can you start the car, too?
Your battery has likely died if you gave negative answers to both of those queries. In the event that you are not at home, you must acquire a jump. Make sure you keep an eye on your car battery going forward to avoid running into another unfortunate circumstance.
Call a Tow/See a Mechanic
In the worst-case scenario, you might need to call a tow truck to have your car towed and yourself sent home (or work or wherever you were going). If you tried all of the aforementioned fixes and they had no effect, then that is. Most likely, there are deeper issues at play than you can address on your own. Allow a mechanic to handle it.
How do I find out which battery my key fob uses?
Open your fob to find the battery your automobile key fob uses. There will probably be an engraving that starts with CR followed by a string of digits if the item contains a battery. Check your owner’s manual or search online for your car’s make, model, and year without a battery or engraving.
Will changing the battery on my key fob make it work again?
A dead battery is the most frequent cause of a key fob not functioning. Having said that, your keyfob might be having more serious issues. A key fob replacement or even automobile door lock repair may be necessary if it stops operating after a battery change.
How do I know if changing my key fob battery will fix my car key?
When the key does not function under any conditions, it is likely that the car key fob has a dead battery. On all door locks, all buttons have the same lack of effectiveness. When buttons are pressed, no lights illuminate, suggesting that no signal was transmitted. The backup fob, however, functions flawlessly.
What do I do if my key fob is not working after a battery change?
Before you replace the automobile remotes if your key fob still won’t work after a battery change, make sure your locks are operating properly. Additionally, make sure you didn’t unintentionally deprogram your keychain.
Can you fix a key fob not working after a battery change?
Although replacing the remote’s batteries might be the quickest repair for the problem, this is by no means your only option. Check to see if the key fob or the vehicle is the root of your issue. After determining the root cause, correct or change the damaged components.
How is a key fob for a 2010 Toyota Corolla programmed?
Having an extra set of keys handy is usually a smart idea, whether you decide to keep them in the house or give them to a friend or family member. However, you must make sure that they are properly programmed before they can be of any value.
Follow these easy steps to program a key fob for a 2010 Toyota Corolla:
- Open your automobile door, close it, and then reopen it to activate programming mode.
- Close the door after inserting the key into the ignition.
- One key turn to the ON position will do. Never start the car.
- You should now be able to add a new remote after turning the car off.
- Your ignition key needs to be removed.
- Two seconds should be spent holding down the lock and unlock buttons on the key fob before releasing them.
- Your key fob should be programmed after doing this twice.
Keep in mind that your new key fob should be configured if you purchased it from an auto locksmith or dealership. If it’s not, get in touch with them.
You can be sure that you’re protected in case of a lockout now that your Toyota key fob has been properly programmed. In addition, since we’re on the subject of coverage, make sure to check out the Jerry app to see how much money you may save on your auto insurance.
After you download Jerry, all you need to do is respond to a few questions that will take you around 45 seconds to do, and you’ll get car insurance rates for coverage that is identical to your current plan right away. Customers of Jerry save $879 year on average.
How is a key fob for a 2009 Toyota Corolla programmed?
Previously a cool extra, remote entry devices are now commonplace in many cars. While some current key fobs require dealer programming, older ones can probably be configured manually.
To program your 2009 Toyota Corolla key fob, follow these instructions:
- Leave your driver’s side door open and unlocked as you take the wheel.
- Put the ignition on with your key (dont turn the ignition on). Take that out. Then carry out the procedure a second time.
- Twice close and open the door on the driver’s side.
- Pull remove your key after inserting it into the ignition.
- Two more times, shut and reopen the driver’s side door.
- Place your key in the ignition and leave it there for now.
- Keep the driver’s side door closed.
- Without starting the engine, turn the ignition to ON, then turn it back off.
- When you remove the ignition key, the locks should cycle to indicate that you are in programming mode.
- Your new key fob’s lock and unlock buttons should be held down for two seconds each before releasing.
- Repeat for a further two seconds before releasing.
- To verify that your remote is programmed, the vehicle’s locks should cycle.
- Open your door to exit programming mode. Test the key fob after that!
Although it could appear complicated and time-consuming, this process should just take a short while. On the other hand, if you’d prefer not to program it yourself, you may always bring your car and new key to a dealer.
Take a moment to reduce your auto insurance with Jerry while you’re waiting to have your key coded. The Jerry app, a certified broker, assists users in saving $879 annually on auto insurance on average. Simply download the app, respond to a few questions, and Jerry will provide you free assistance in comparing rates from more than 50 leading providers.
Do you need to reconfigure your key fob after changing the battery?
A remote key fob needs to be associated with your vehicle particularly in order to be secure.
This stops people who drive the same make and model of automobile as you from using their remote to access your car. You’ll need to reprogram the fob if changing the batteries has erased this connection or if it was somehow disrupted in order for it to once again recognize your automobile.
Standard programming sequence
Your key fob can typically be reconfigured by following this typical procedure:
Instead of starting and then returning to the locked position, turn the key into the run position. Repeat this multiple times.
You’ll typically hear a chime or other sound when you’ve cycled the key enough times. At that point, you can push the lock or unlock button on your key fob to hear another chime.
What happens if the battery in my key fob dies while I’m driving?
This issue has been foreseen by automakers ever since the key fob was created. Nothing will happen if your key fob dies while you’re driving. Simply because the key fob is a locking and starting device only, the automobile will continue to run. The key fob has no influence over the ignition or engine once the automobile is moving.
Even though you’ll need to go to a general store or pharmacy to get the battery, replacing the battery in your key fob simply takes a few minutes if you’re pressed for time.
Why not take the time to renew your auto insurance at the same time as you’re replacing the batteries in your key fob?
You can access a new quotation with just a few taps on your phone screen by downloading the Jerry app and answering a few questions.
Jerry assists you in finding and comparing rates from more than 50 leading suppliers in minutes as a licensed broker. Jerry can assist you with purchasing new insurance and even canceling your existing policy when you find a lower rate.
Can I set up my own key fob program?
Many automakers have started designing vehicles with locks that can be unlocked with little more than a key fob since the development of remote technology. The owner of a key fob can easily unlock a door by pressing a button, and many of them can also start their car by pressing a button as long as the fob is inside.
Unfortunately, the dealership may assert that they have property rights over the device and, as a result, only they can make a copy and program it, which comes with an outrageous charge, if a car owner loses their key fob or wishes to make an extra copy. However, while making a new key fob and programming it to function with your automobile may require expert guidance, a knowledgeable locksmith may help you with this task without forcing you to go back to the dealership for assistance.
Wait, is it illegal to create a new key fob without the dealer’s consent?
Some dealers can even claim that if the task is not carried out by a licensed operator, making a new key fob is illegal. However, even if this might be the case with a leased or rented car, you are probably allowed to create as many copies as you want with the assistance of a professional.
Additionally, programming a key fob to work with your car is also not a difficult process. While you shouldn’t attempt to manufacture a copy yourself, a skilled locksmith can provide you with a new key fob quickly.