I’m sad to hear you have a low tire, but I’m glad you were able to go to work. Find the spare tire, tire jack, and tire tools before you begin changing the tire on your 2018 Toyota Camry.
You must first open the trunk and search the interior for a latch towards the front of the trunk. To access all the equipment you need to change your tire, pull the tab and lift the foam cover.
Then, you can change your tire by following these instructions:
- With your wrench, loosen the lug nuts on the hubcap of your tires.
- Put the jack underneath the frame of your car. Before lifting your automobile, consult your owners manual to determine the ideal location for the jack.
- Remove the flat tire by completely removing the lug nuts.
- To install the spare, align the tire’s holes with the lug nut posts.
- The lug nuts should only be secured loosely.
- Start tightening the lug nuts after lowering your automobile until the wheels just barely contact the ground.
- Completely lower the vehicle. After the car has been completely lowered, you might be able to tighten the lug nuts even more.
You can drive safely now that your tire has been changed. Check out the Jerry app to see how much you may save on auto insurance before you get back on the road.
After you download Jerry, all you need to do is respond to a few questions that will take you around 45 seconds to do, and you’ll get car insurance rates for coverage that is identical to your current plan right away. Customers of Jerry save $879 year on average.
In This Article...
How does a 2018 Toyota Camry’s spare tire come off?
The 2019 Toyota Camry is a pleasure to drive because to its beautiful exterior, entertaining driving dynamics, and luxury interior. It’s a great choice for running errands around town or the early commute. No matter where you’re going, a flat tire can rapidly ruin an otherwise pleasant day. Even though a flat tire can be a real annoyance, being prepared can greatly reduce the negative effects it has on your day. Locate the spare tire and tools before your subsequent drive so that you may quickly access them when necessary.
Locating the Spare Tire and Tools
Open the Camry’s trunk and seek for the latch to gain access to the spare tire and tools. It’s a rectangular piece of plastic with a handle in the front. To access the handle, pull the tab in your direction. Then, lift the floor using the handle. Additionally, the handle doubles as a hook that may be hung from the seal beneath the back window. The jack and tools will be visible inside a foam tire cover in their designated locations. To access the tire, raise the cover out of the way. Use your hands to unscrew and remove the plastic retaining bolt from the tire. Lift the tire out after that.
There are a few things you can store with the tire to make the operation safer and simpler even if they aren’t technically necessary. These contain a poncho or raincoat, gloves, a 2×6-inch piece of wood, a flashlight, and a flashlight with batteries. A reflective traffic triangle and wheel wedges might add an additional level of protection.
Do 2018 Toyota Camry models come with spare tires?
The spare tire that comes with the Toyota Camry is not the usual spare tire; rather, it is a “space saving spare tire” that is reduced in size. This will function adequately to bring you to a shop where a new tire may be put on your car.
Where is the jack located on a 2019 Toyota Camry?
Welcome to the world of do-it-yourself car repairs! It’s a fun way to save money, and understanding how your car works only has benefits. Although a chaotic place to start, this is also a fantastic way to learn.
There are four jack points on practically every car’s frame, including the Toyota Camry. The front ones are directly adjacent to the inner hinge line of the door, behind the front wheels. In front of the rear wheels are the jack points for the rear (on the driver end, not the trunk end).
It’s a good idea to initially examine the car’s undercarriage while squatting on the ground with your dependable smartphone flashlight. The jack points are located in the regions we just mentioned, and they differ slightly from the rest of the car’s frame in appearance.
To make sure you know exactly where the car’s jack points are, you should absolutely examine your car’s manual. You’ll be referring to that manual a lot as you delve into the DIY mechanic hobby. You can find it on the manufacturer’s website if you don’t already have it.
Some vintage automobiles, trucks, and SUVs won’t have designated jack points. Instead, you’ll have to make use of the vehicle’s frame. Yet again, before attempting to jack up the automobile, always refer to your vehicle’s manual.
Jerry, the top-rated insurance app in America, is made to accomplish just that. After you download the app and respond to a few straightforward questions, Jerry gets you affordable car insurance without compromising on coverage. Even to cancel your old coverage, you don’t need to make a single phone call.
More than a million people who use Jerry annually save $887 on vehicle insurance. Additionally, you’ll save a ton of money on your homeowners and renters insurance. Try Jerry out right away to see how much you can save!
What steps are involved in replacing a tire?
Tire flat and stuck? Here are the 10 steps to changing a tire.
- Locate a Secure Overpass to Pull Over.
- Inspect the materials.
- Take off the lug nuts.
- Your car should be raised off the ground.
- Remove the Tire and the Lug Nuts.
- Fix the spare tire to the vehicle.
- Switch out the lug nuts.
- Lower the car and start tightening.
FIND A SAFE LOCATION
Do not suddenly brake or turn when you first notice you have a flat tire. Slow down and look about for a straight, flat section of road with a wide shoulder. The best location would be a parking lot that was empty. It is advantageous to have level terrain since it will keep your car from rolling. Furthermore, straight sections of road are preferable to curves since they increase the likelihood that incoming vehicles will spot you.
Never try to replace a tire near oncoming traffic on a small shoulder. Move forward (slowly) until you reach a safer location. Although driving on a flat tire puts your rim at danger of damage, this is better than getting struck by an inattentive motorist.
Make sure to examine the precise instructions for changing a flat tire for your vehicle in your owner’s manual.
TURN ON YOUR HAZARD LIGHTS
Other drivers will be able to see you on the side of the road thanks to your hazard lights or flashers. They should be turned on as soon as you recognize you need to stop in order to prevent an accident.
APPLY WHEEL WEDGES
To make sure the car doesn’t slide while you patch the flat tire, wheel wedges are placed in front of or behind the tires. Put these in front of the front tires if you’re changing a rear tire. Put the wheel wedges behind the rear tires if the front tire is flat.
Real wheel wedges are not necessary; you can just use bricks or big stones. Simply make sure they are substantial enough to prevent the automobile from rolling.
REMOVE THE HUBCAP OR WHEEL COVER
It is simpler to take off the hubcap before raising the car with the jack if your car has one covering the lug nuts. You can move on to Step 6 if your lug nuts are visible.
To remove the hubcap, use the flat end of your lug wrench. Most automobiles can use this, but some hubcaps require a specialized tool to remove. For instructions on how to remove a hubcap or wheel cover properly, go to your owners manual.
LOOSEN THE LUG NUTS
Turn the lug nuts counterclockwise with the lug wrench until they lose their resistance. It’s okay if you have to use force. If required, use your foot or your entire body weight.
The lug nuts should be loosened by 1/4 to 1/2 turn, but not yet totally removed. Save that for when you need to take your tire or wheel off the car.
PLACE THE JACK UNDER THE VEHICLE
Under the car’s frame, next to the flat tire, is normally where the jack should be placed. A cleared piece of exposed metal on the bottom of many car frames is designated for the jack and is covered in molded plastic. Use the jack in accordance with the owner’s manual’s directions to properly lift the object without causing harm to the car.
RAISE THE VEHICLE WITH THE JACK
Before attempting to elevate your vehicle, lay a little cut of 2×6 wood beneath the jack to keep it from collapsing under the weight of your car and losing equilibrium. On asphalt, this strategy is very useful.
Lift the car with the jack in the right place until the flat tire is roughly six inches off the ground.
Never place any portion of your body under the car while it is being raised with the jack or later.
REMOVE THE FLAT TIRE
Pull the tire gently in your direction while holding it by the treads until it is totally free from the hub behind it. To prevent it from rolling away, position it on its side.
TIGHTEN THE LUG NUTS BY HAND
Reinstall the lug nuts on the lug bolts and manually tighten them all the way. Once they are all attached, double-check each one and tighten as much as you can. After lowering the car to the ground, you’ll use the wrench to tighten them.
LOWER THE VEHICLE AND TIGHTEN THE LUG NUTS AGAIN
Lower the car using the jack so that the spare tire is on the ground but that the tire isn’t bearing the entire weight of the car. Now, using the wrench and rotating in a clockwise direction, tighten the lug nuts as much as possible. Use your entire body weight to press down on the lug wrench.
LOWER THE VEHICLE COMPLETELY
Remove the jack and fully lower the car to the ground. To make sure the lug nuts are as snug as possible, give them one more tug with the wrench.
REPLACE THE HUBCAP
Put the hubcap you removed from the flat tire back on if it fits your spare tire after first removing it. If it won’t fit, store it with the tire when you store your equipment if it isn’t necessary.
STOW ALL EQUIPMENT
A jack, a lug wrench, wheel wedges, your flat tire, and perhaps a hubcap are the items you have in front of you. Before you go, remember to load them all into your car.
CHECK THE PRESSURE IN THE SPARE TIRE
To make sure the spare tire is secure for driving, you should check the tire pressure. Mini-spares, commonly known as T-Type temporary spares, need 60 psi (420 kPa). If the tire has to be inflated, proceed (slowly) to a gas station right away.
TAKE YOUR FLAT TIRE TO A TECHNICIAN
Driving long distances or at high speeds is not recommended with temporary spare tires, so proceed with caution until you can see a tire technician. If your tire needs to be repaired or needs to be replaced, a professional should be able to tell.
Is there a spare tire included with the Toyota Camry?
The fact is that a trim with a spare tire is available on almost all popular car models in America. The top models in each of their respective categoriesthe Ford F-150, Toyota RAV4, Toyota Camry, and Toyota Civicall come with a spare tire as standard equipment. Nine Honda Civic trims with a spare were in our count. This disproves just about every defense a manufacturer may make for why a spare tire is not feasible. It is a possibility if the models and trims with the highest sales have one.