Set the key to the “On” position in the ignition with the car off, but don’t push the starter. Once the TPMS light has flashed three times, let go of the tire pressure monitor reset button. Start the engine and give the sensor 20 minutes to refresh.
In This Article...
How To Reset The Tire Pressure Sensor On The Hyundai Sonata For Models From 2007 to 2018
Driving the vehicle for at least 10 minutes at a speed of 50 mph or higher is the simplest way to reset the tire pressure sensor on every Hyundai Sonata vehicle.
You must manually reset the tire pressure light if it remains on after 10 minutes of driving. From 2007 to 2018, all Hyundai Sonata models can be repaired using the following procedure.
Locate the TPMS reset button in step two (usually underneath or to the side of the steering wheel).
Step 3: Hold down the tire pressure monitoring reset button while waiting for three consecutive flashes of the tire pressure warning light.
Step 5: To fully reset the sensor, start the vehicle and let it run for 20 minutes.
Step 6: The tire pressure light ought to go out after the TPMS sensor has been manually reset.
Anonymous
TPMS is an acronym for Tire Pressure Monitor System. When feasible, check and adjust all tire pressures while they are still cold in accordance with the tire pressure label located on the driver’s door jamb, glove box, another door jamb, or the center console compartment (inside). even check the tire pressure in the spare. When one or more tires have significantly different air pressure from the rest, the warning light will illuminate to let you know. Once the pressures have been set properly, consult the owner’s manual to learn how to reset or turn off the light. If you drive your car for a bit, the light on many cars will reset and turn off. Hope this is useful.
What does the 2008 Hyundai Sonata’s TPMS light mean?
TPMS alert signal Check the air pressure in each tire and make any necessary adjustments when the low tire pressure warning light illuminates. Repair the tire as necessary if it has damage.
On a Hyundai Sonata, how do you reset the low tire pressure indicator?
Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
Without a reset button, how do you reset a TPMS?
How to Reset the Tire Pressure Light Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light should not be on because the tire sensors should have been reset.
Why does the TPMS light not go out?
Don’t start the car; just turn the key to “on.” Till the tire pressure light blinks three times, press and hold the TPMS reset button. Press the button again to start the vehicle. The light ought to turn off in 20 minutes.
What does the Hyundai Sonata’s TPMS acronym mean?
A Hyundai tire pressure monitoring system, often known as a Hyundai TPMS, is an electronic device that checks the tire pressure in a vehicle and immediately alerts the driver if the tire pressure is too low or too high.
My TPMS light won’t turn off; why?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
How much time does a TPMS take to reset?
Hold down the TPMS reset button until the tire pressure warning light flashes three times. Release the reset button after that. Start the car, then wait for the sensor to refresh for around 20 minutes. Under the steering wheel is usually where you’ll find the reset button for the tire pressure monitor.
Why are my tires fine but my TPMS light is on?
It’s likely that one or more of your tires have low air pressure if you see the tire pressure indicator turn on. However, even if your tires are in good condition, there are a number of things that could cause the sensors to go off, so you shouldn’t rely only on the data from the tire pressure monitoring system of your car.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
Will removing the battery reset the TPMS?
Each vehicle has an onboard computer, which occasionally experiences technical difficulties. Resetting the computer is the best approach to address these issues, and you may do this by removing and reinserting the battery. Locate the negative terminal of the battery by opening the hood of your car. Press the car’s horn to drain any leftover power after removing the negative connector to disconnect the battery. Once the positive terminal is connected again, the TPMS warning light should stop flashing.
The significance of a steady TPMS light
It usually indicates that one or more tires need to be inflated to the recommended placard pressure if the TPMS warning light glows solidly and stays solid.
The TPMS system, however, is malfunctioning if a light flashes for 60–90 seconds before going solid. Most likely, there is a communication problem between the vehicle and one or more of the sensors. Many different problems may be the root of this. The sensor may need to be changed if it is broken, missing, or has a dead battery, according to the flashing light. It can also imply that the tire’s sensor is placed incorrectly.
You must investigate these potential problems until you identify the source if you want to ensure that you service the TPMS systems correctly.
When your customer visits for servicing, bear in mind the following extra advice:
Every time a customer’s car pulls into your service bay, check the Telltale/MIL and note the presence of any lit or blinking lights before starting any work.
Visually check the stems, hex nut, seal, and cap while servicing the TPMS. Replace with a fresh service kit is the advised best practice.
Whether or not there is a chance for a sale, always let the customer know the advantages of TPMS.
In what location is the TPMS sensor?
Where is the location of the tire pressure sensor? It is affixed to the interior of the rim from inside the tire. The tire pressure sensor is a little cylinder that you can see if you take the tire off the rim.
AutoZone is able to check TPMS sensors.
You can determine if your tire pressure monitoring system is corroding or failing within your wheel with routine inspection; if so, you will need to replace it. For your repair, AutoZone carries every tire pressure monitoring system item you’ll need, enabling you to drive again efficiently and safely.
Can an extra tire turn on the TPMS light?
A tire pressure warning light that illuminates when it detects a change in tire pressure is standard equipment on the majority of new Toyota vehicles, model years 2003 and newer. Rapid and severe temperature variations, which in Vermont tend to coincide with seasonal changes, are the ones that cause tire pressures to fluctuate the greatest.
The Toyota Tire Pressure Monitoring System (TPMS), which is mounted on the tire valves, is intended to alert you when any of the five (yes, FIVE!) tires on your car are underinflated. Low tire pressure in the spare tire of the car is the most typical cause of the warning light to come on. The majority of customers are not aware that their spare tire has a tire pressure monitor put in it, and that donut spares do not have a TPMS fitted. The light could also come on if a tire is ruptured, alerting you to an impending flat tire.
If you’ve examined all five tires and found that they are all properly inflated and free of punctures, it’s still conceivable that your TPMS is broken or otherwise not working properly. Incorrect inflation or damage sustained during a tire installation and balancing, most frequently when carried out by a technician who is not familiar with the system, might result in a broken TPMS. If you believe this to be the case, call or visit Heritage Toyota Scion right away, and one of our staff members will be happy to diagnose the issue and, if required, replace the malfunctioning sensors.
What is the price of a new TPMS sensor?
Replacement of a TPMS sensor typically costs between $208 and $250. Between $55 and $69 is the expected range for labor costs, while $153 to $181 is the range for part costs. Taxes and other costs are not included in this range, nor are your particular vehicle or geographic area taken into account. Additional fixes could be required.
What occurs if the TPMS battery runs out?
The Tire Pressure Monitoring System, which notifies you when a tire is dangerously low on air, typically uses TPMS sensors embedded in the tires to detect low tire pressure. The majority of TPMS sensors use internal batteries that cannot be changed to power them.
The lithium ion batteries in a TPMS sensor have a lifespan of 5 to 10 years. The duration of the TPMS sensor batteries is difficult to predict because it depends on how many radio frequency broadcasts the sensors send out. The amount of driving you perform over time and the conditions you drive in will affect the sensor battery life. The TPMS battery life is less affected by cold conditions than by warmer ones. When compared to continuous pace, stop-and-go traffic has a greater effect on TPMS battery life. This is due to the fact that sensors send out more radio frequency broadcasts as a vehicle changes its speed.
The system will issue a malfunction warning when a TPMS sensor’s battery runs out, which will be visible as a blinking TPMS light on your dashboard. After 60 to 90 seconds, the light may either continue to flash or turn solid. Be a repair appointment as soon as you can if you receive this warning, but also check the tire pressure in each tire right away to make sure you have safe inflation all around.
You can change each individual TPMS sensor separately if one of them malfunctions and needs to be replaced. The other sensors, on the other hand, are probably on the verge of failing as well if the failure was brought on by a dead sensor battery. You might wish to proactively replace all the sensors so you have brand-new sensor batteries all around when you take into account the time and hassle of taking your car off for a sensor replacement.