Set the key to the “On” position in the ignition with the car off, but don’t push the starter. Once the TPMS light has flashed three times, let go of the tire pressure monitor reset button. Start the engine and give the sensor 20 minutes to refresh.
In This Article...
How To Reset The Tire Pressure Sensor On The Hyundai Sonata For Models From 2007 to 2018
Driving the vehicle for at least 10 minutes at a speed of 50 mph or higher is the simplest way to reset the tire pressure sensor on every Hyundai Sonata vehicle.
You must manually reset the tire pressure light if it remains on after 10 minutes of driving. From 2007 to 2018, all Hyundai Sonata models can be repaired using the following procedure.
Locate the TPMS reset button in step two (usually underneath or to the side of the steering wheel).
Step 3: Hold down the tire pressure monitoring reset button while waiting for three consecutive flashes of the tire pressure warning light.
Step 5: To fully reset the sensor, start the vehicle and let it run for 20 minutes.
Step 6: The tire pressure light ought to go out after the TPMS sensor has been manually reset.
How to re-set the tire pressure on a Hyundai Sonata
Once the TPMS light has flashed three times, let go of the tire pressure monitor reset button. Start the engine and give the sensor 20 minutes to refresh. Under the steering wheel is typically where you’ll find the TPMS reset button. Consult your owner’s handbook if you are unable to locate it.
How to reset the tire pressure light on a Hyundai Sonata 2020 is another common query. When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button. Consult the owner’s manual for your car if you can’t find it.
How to reset the tire pressure light on a Hyundai is another common question. Release the TPMS reset button after holding it down while waiting for the light to blink three times. To reset the sensor, start the engine and let it run for 20 minutes. The reset button for the tire pressure monitor is often located underneath the steering wheel.
A 2018 Hyundai Sonata’s tire pressure light needs to be reset, too. Hold down the tpms reset button on the 2018 Hyundai Sonata until the tire pressure light blinks, then start the car and wait for around 20 minutes.
Furthermore, where is the 2017 Hyundai Sonata’s TPMS reset button? Make sure the tire pressure is right before starting the 2017 Hyundai Sonata to reset the TPMs. After 10 minutes, press the reset button, which is located to the right of the steering wheel. You might need to keep pressing the button until the light flashes in some circumstances. A button with the label “tpms” or something similar is located to the right of the steering wheel. When it starts to blink, hit it and keep it down. Once it blinks, let the car sit for roughly 20 minutes so that it can readjust.
What does the Hyundai Sonata’s TPMS light mean?
Your Hyundai Sonata’s tire pressure monitoring light turning on indicates that one or more tires are either under- or over-inflated. To keep you safe while driving on the road and to prevent any damage to your tires, car tires must be filled to a specified PSI.
A Hyundai Sonata should have a PSI of 34. The tire pressure light on your car’s dashboard will turn on if the tire pressure monitoring system determines that the tire pressure is either too high or too low. The tire pressure sensor needs to be reset after your tires have been inflated to the recommended PSI.
If you don’t know how to reset the tire pressure sensor on a Hyundai Sonata, this page contains all the instructions you require. For detailed instructions on how to reset the TPMS on every Hyundai Sonata model from 2007 through 2020, keep reading.
What does the 2009 Hyundai Sonata’s TPMS light mean?
Check the air pressure in each tire and make any necessary adjustments when the low tire pressure warning light illuminates. Repair the tire as necessary if it has been damaged. Make sure the alarm light is turned off. There is a TPMS issue if the warning light is still on.
On a Hyundai Sonata, how do you turn off the tire pressure light?
Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
Is my car safe to drive with the TPMS light on?
To avoid seeming like Debbie Downer, we’ll simply say no. Driving around with your TPMS light on is not safe. You can’t tell how quickly your tire is losing air or how long it has been over- or underinflated without doing a tire examination. The best course of action is to check the current inflation level of each tire with a tire pressure gauge.
When the tire inspection light appears while you are driving, slow down and get to the closest gas station or service facility.
Will removing the battery reset the TPMS?
Each vehicle has an onboard computer, which occasionally experiences technical difficulties. Resetting the computer is the best approach to address these issues, and you may do this by removing and reinserting the battery. Locate the negative terminal of the battery by opening the hood of your car. Press the car’s horn to drain any leftover power after removing the negative connector to disconnect the battery. Once the positive terminal is connected again, the TPMS warning light should stop flashing.
AutoZone is able to check TPMS sensors.
You can determine if your tire pressure monitoring system is corroding or failing within your wheel with routine inspection; if so, you will need to replace it. For your repair, AutoZone carries every tire pressure monitoring system item you’ll need, enabling you to drive again efficiently and safely.
Where are TPMS installed?
Where is the location of the tire pressure sensor? It is affixed to the interior of the rim from inside the tire. The tire pressure sensor is a little cylinder that you can see if you take the tire off the rim.
What occurs if TPMS sensors are not replaced?
Customers who ask you to turn off their TPMS light just and leave the underlying problem unattended can put you and your business at unnecessary risk. Without addressing the problem, you are breaking the NHTSA’s “make inoperative” clause, which makes shops legally obligated to disable the TPMS. It is your duty to let the customer know this and to decline service if they don’t want the problem handled properly.
It is strongly advised to replace all sensors at once if a single sensor has reached the end of its useful life. When one sensor fails, the others are likely to follow suit quickly, just like with headlights. The same holds true for replacing an impact sensor or damaged valve stem. Your consumers should be aware of this since it will assist you give their vehicle the finest care possible. They also find it convenient.
The TPMS sensors must always be reactivated and calibrated for drivers who change their tires as the seasons change. If you don’t do this, the car’s TPMS won’t function properly and could turn on the TPMS light.
The significance of a steady TPMS light
It usually indicates that one or more tires need to be inflated to the recommended placard pressure if the TPMS warning light glows solidly and stays solid.
The TPMS system, however, is malfunctioning if a light flashes for 60–90 seconds before going solid. Most likely, there is a communication problem between the vehicle and one or more of the sensors. Many different problems may be the root of this. The sensor may need to be changed if it is broken, missing, or has a dead battery, according to the flashing light. It can also imply that the tire’s sensor is placed incorrectly.
You must investigate these potential problems until you identify the source if you want to ensure that you service the TPMS systems correctly.
When your customer visits for servicing, bear in mind the following extra advice:
Every time a customer’s car pulls into your service bay, check the Telltale/MIL and note the presence of any lit or blinking lights before starting any work.
Visually check the stems, hex nut, seal, and cap while servicing the TPMS. Replace with a fresh service kit is the advised best practice.
Whether or not there is a chance for a sale, always let the customer know the advantages of TPMS.
How much will a new TPMS sensor cost?
Replacement of a TPMS sensor typically costs between $208 and $250. Between $55 and $69 is the expected range for labor costs, while $153 to $181 is the range for part costs. Taxes and other costs are not included in this range, nor are your particular vehicle or geographic area taken into account. Additional fixes could be required.
How frequently should TPMS sensors be changed?
5–10 years is a likely lifespan for TPMS sensors, which are built to last for many years. Given their price, most drivers will opt to repair TPMS sensors “as needed,” that is, only when their batteries run out or other TPMS components malfunction. (The onboard computer in your car ought to react and issue a warning of a TPMS issue or failure.)
Typical TPMS issues that necessitate sensor replacement include:
- TPMS sensor battery failure
- broken TPMS sensors
- Gaskets and/or seals for the TPMS sensor are worn out.
- The TPMS sensor doesn’t send a signal (many possible causes)
- The TPMS valve cores or caps seize up.
When purchasing new wheels, is a new TPMS required?
The quick answer is that you can utilize your old TPMS with your new wheels and tires, but we’ll go through some other things to think about below.
Why won’t my tire pressure warning light turn on?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.