How To Reset Low Tire Pressure Hyundai Santa Fe?

Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.

In This Article...

On a 2021 Hyundai Santa Fe, how do you reset the tire pressure indicator?

On a Santa Fe 2022, how do you reset the tire pressure light?

Drive the vehicle for around 10 minutes at 50 mph.
Turn the ignition key to the “On” position without starting the automobile.
After three seconds, or when the light has flashed three times, let go of the TPMS reset button.
To reset and calibrate the sensor, start the engine and let the vehicle run for 20 minutes.

The reset button for the tire pressure monitor is often located under the steering wheel on Hyundai Santa Fe vehicles.

You could also wonder why the tyre pressure indicator is still on after the tires have been inflated. If your tire pressure monitoring system is malfunctioning or there is a persistent leak, the air pressure warning light may continue to glow even after you have inflated your tires.

Use a pressure gauge to confirm that the tire is properly inflated to the recommended air pressure if the TPMS warning light comes on again after you’ve inflated it.

How do you remove the low tire pressure alert?

When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is normally where you’ll find the reset button for the tire pressure monitor. If you can’t find it, consult the owner’s manual for your vehicle.

Why, after filling the tires, does my tire pressure light remain on in a Hyundai?

If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.

Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.

My tires are in good condition, so why is my low tire pressure sign on?

The primary danger is that one of your wheels might not have enough air in it. Normally, if one of your tires is more than 25% under-inflated, the low tire pressure indicator will on.

The wheel could explode, also known as a tire blowout, if you ignore the warning and continue driving.

You’ve probably seen the disastrous effects a blowout can have on vehicle accidents, so this is definitely not something to take lightly. Other drivers on the road are also at risk in addition to you.

For this reason, even if you are certain (or believe you are certain) that the TPMS warning light is going on when your tires are adequately filled, you should never disregard it.

Why do my car’s tires, which are good, state they have low tire pressure?

While the tires appear to be in good condition and the low tire pressure light is ON, you can:

simply press a button to reset the machine and observe the results; or
The sensors need to be changed since one or more of them are damaged.

After starting the vehicle, the low tire pressure warning light ought to turn on for a few seconds. The light ought to be turned off right away.

Drive your car, preferably to the closest gas station or tire shop, to check the air pressure in each tire if the low tire pressure warning light is still on.

Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.

But if the low tire pressure warning light is still on and all the tires are adequately inflated and warmed up, move on to the next step.

Take this opportunity to get out the owner’s manual. The TPMS reset button may be found on the console or in the glove box, depending on the make and model of your car.

Here are the steps to take after finding the TPMS reset button:

Don’t start the engine after turning the key to the ON position.
For at least three seconds, press and hold the TPMS reset button before letting go. The system will switch off the warning light and produce a beep or other audible alert.
To finish the reset process, start the engine and drive the vehicle for 30 to 1 hour at a minimum speed of 19 mph.
It’s time to check or replace the TPMs sensors if the warning light comes back on.
To get the system tested, drive to the nearest tire store or dealership.

If your car has TPMS, avoid making it a practice of resetting it every time the low tire pressure warning light comes on.

Your safety is considered during the system’s design. The pace of technological advancement means that the TPMS sensors get better with each new model. However, you should make it a practice to check the tire pressure each time you get in the car in order to get the most out of what you have.

Use a different method than the TPMS to check the tire pressure. A quick visual check is sufficient to establish the existence of a flat.

Here’s a helpful hint: just in case, always have a tiny tire pressure gauge in the glove box. You may check the real tire pressure with this straightforward gadget before the TPMS activates.

Take your vehicle to the shop so they can “re-learn” the sensor with a specific tool if your TPMS light is still on. These tools are available online, but they are not inexpensive. I would advise researching the Autel TS501.

Why won’t my tire pressure warning light turn on?

When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.

*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.

Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?

Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.

What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?

The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.

My tire pressure is fine, so why won’t the light go off?

How to Reset the Tire Pressure Light Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light should not be on because the tire sensors should have been reset.

Can the tire pressure monitoring system be turned off?

Yes, it is possible to disable your tire pressure monitoring device using a smart, non-intrusive approach. You only need to use an emulator created to get around the TPMS. The TPMS bypass emulator is a tiny box-shaped gadget containing technology that allows you to “switch off” your tire pressure monitoring system.

What is the Hyundai Santa Fe’s TPMS?

Hyundai vehicles are equipped with TPMS, or tire pressure monitoring systems, which may detect low tire pressure in any of the car’s four tires and issue an alert. According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle.

According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle. The tire pressure monitor ECU/receiver receives the data from the sensor, which detects the pressure and temperature inside the tire, together with the TPMS’s distinctive ID.

If the TPMS ID is stored with the ECU, the placard pressure is checked with it, and if there is a pressure difference, a warning light is illuminated on the dash-mounted display.

Should the TPMS be reset after purchasing new tires?

After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.

Will the tire pressure light automatically turn off?

Tire pressure can be impacted by overnight temperature variations or by cold winter days. The low-pressure indicator may then display as a result of this. The pressure in your tires can change by up to 10 PSI when there are significant temperature changes between day and night.

After about 20 minutes of driving, the light may turn off on its own when the right inflation level stabilizes and the air in your tires warms and expands.

In any case, you ought to have your air checked immediately. Your tires are at least 25% underinflated, according to the TPMS light. This poses a risk to your safety, especially if the load is close to your vehicle’s maximum load capacity. There is a higher possibility of tire failure, degraded handling, and increased tire wear and tear. Your fuel economy may also suffer.

How far can you travel when the pressure is low?

A 50-mile drive at a top speed of 50 mph is conceivable in the event of complete pressure loss and limited mobility (no unexpected driving maneuvers). The type of driving, speed, type of road, weather, tire condition, and vehicle load will all have an impact on the run flat distance.

How long should the tire light be on when driving?

Low tire pressure makes the situation worse because it is more difficult to gain traction and roll ahead. Under these circumstances, avoid driving with low tire pressure for more than 40 miles or more than 30 minutes.

How does the TPMS identify each tire?

The anti-lock brake system’s wheel speed sensors are often used by an indirect TPMS. On-board computer systems can employ these sensors to compare wheel revolution rates between individual wheels as well as to other vehicle operation data, such as speed.

The computer can determine the relative size of the tires on your car based on how quickly each wheel rotates. The computer determines that a tire is underinflated when a wheel starts spinning more quickly than normal and warns the driver accordingly.

So a system that monitors tire pressure indirectly does not genuinely detect tire pressure. The same kind of measurement you may observe with a tire gauge is not being processed electronically. An indirect tire pressure monitor only counts the rotational speed of your tires and sends instructions to the computer to activate the indication light when something seems off with the rotation.