Registered
My 2010 328xi’s headlight was broken, so I replaced it. On the contrary, the dash’s indicator light is still on. I tried to reset it using the instructions in the owner’s manual, but I was unable.
In This Article...
How are the BMW warning lights reset?
Find the tiny odometer button in the instrument panel’s lower left corner. until the service message shows, press and hold. When the message says “Reset,” let go of the button and press and hold it once more.
What does BMW’s warning light for light bulbs mean?
Service Vehicle: A yellow symbol will appear when your vehicle needs maintenance. It will turn red if your BMW vehicle’s maintenance is past due. Light Bulb: One or more of the exterior lights are broken or malfunctioning. It is required to schedule a service appointment if you replace the bulb and the symbol does not turn off.
On my BMW, how can I reset the exclamation mark?
Try a quick reset if your BMW is operating OK but you notice the exclamation mark warning. Just shut off the car and start it again. This frequently resets the warning.
After a reset, if the engine light, check engine light, or gear with an exclamation mark returns, the vehicle needs to be inspected. Low battery voltage might be the cause of an intermittent warning light. Any warning light, though, needs to be examined right away.
Error codes like P0174, P1347, or p0174 can be produced with a short diagnostics check. These codes typically signal common engine issues like a misfire. However, underlying issues can be to blame, so a local dealer or mechanic will need to investigate.
How is the maintenance needed light reset?
- Switch the ignition to the ON position.
- Set the trip display to TRIP A mode on the odometer.
- Activate the OFF position on the ignition switch.
- Turn the ignition switch to the ON position while pressing and holding the Trip Meter RESET button.
- The service reminder light for maintenance will
Why does my BMW have a lane departure indicator on?
The City Brake Activation system and the camera-based Lane Departure Warning and Approach and Pedestrian Warning systems are combined in the Driving Assist feature. At speeds over about 70 km/h, the Lane Departure Warning recognizes lane lines and vibrates the steering wheel to warn the driver of an inadvertent lane shift. If the lane change is intentional, that is, when the turn indicator is on, the warning is not activated.
The Pedestrian Warning with City Brake Activation responds to pedestrians whereas the Approach Warning with City Brake Activation detects automobiles. The Approach Warning initiates a two-stage warning when there is a potential for collision. The instrument cluster’s symbol first illuminates before an audible alarm sounds. In the event of an immediate risk of collision, the pedestrian warning initiates a single-stage warning. The brakes are simultaneously preconditioned for a quicker response if the system forewarns of a probable accident. The system applies the brakes during an emergency.
Along with Approach Warning and Lane Departure Warning, the Driving Assist Plus feature (only available with Automatic Transmission Steptronic) also has Active Cruise Control with Stop&Go functionality. This helps when driving on highways in both emergency and non-emergency traffic scenarios.
In stages, the Approach Warning reacts. The response varies from a visual alert to active braking and even a complete stop depending on whether a vehicle ahead brakes unexpectedly or whether a stationary item is noticed. With the use of vibrations in the steering wheel, the Lane Departure Warning rapidly issues a warning if the vehicle starts to lane-change without the driver’s knowledge.
If the distance control is on, the Active Cruise Control automatically changes its speed to match that of the vehicles in front of it. Otherwise, it maintains the selected speed between 30 and 210 km/h. When the gas pedal is depressed, the Stop&Go feature even manages speed down to a standstill before simply resuming acceleration, for instance in heavily moving traffic.
How far must you travel to turn the check engine light off?
Most likely, the problem with your check engine light has been resolved, but it’s still on. And you’re growing annoyed by it. Maybe you spent a fortune on it.
You probably don’t know this, but you need to drive for 50 to 100 miles after clearing the car’s computer.
The computer in your car will keep track of all the sensors’ readings while you drive and record them.
Details are as follows:
After resetting the codes, your automobile hasn’t been driven for enough time. Solution: Continue driving until the system flashes READY.
But wait, there are still some very crucial items to consider. So let’s look more closely.
What does the BMW yellow triangle mean?
The 2014 F32 428i I own. Could someone please explain to me what the sign on the dash in my picture means? It has a yellow triangle inside of which is an exclamation point. Both TPMS and traction control are not what it is. Yes, I read the handbook from cover to cover, but I couldn’t find it. I’ve only observed it happening twice in the past week, and each time it just lasts a few minutes. The iDrive screen doesn’t show any additional messages when it occurs. Anyone? I appreciate it.
These cars do have a two-tier gas light, though. At 30 miles remaining, the huge, obvious one approaches me, and at 50 miles remaining, the warning light turns on before leaving that triangle.
At least one Check Control message is displayed or is stored (symbol in display), according to page 79 of my owner’s manual. It seems like there ought to be another message visible.
On the keypad, press menu. Then, go to vehicle status>check control on the screen, and it will read all messages that are responsible for the triangle. Yellow often only denotes a non-urgent indication, such as low gasoline or tire pressure, whereas red denotes a more urgent message, such as a door open or an unbuckled seatbelt.
Says “all systems ok” at this time, but I’ll know where to go check the next time the small light comes on. I appreciate this.
I have vivid memories of witnessing it as the back-end slips. I don’t recall seeing yours either. In my situation, I’m not sure what it means. Possibly sporadic warning
I never noticed that in my F32, which has traction control, or my F82, which has much more tail-happy behavior.
Recently, for me, a light went on in this area. The auto-aiming LED headlights weren’t operating, it claimed when I went into the car status panel. After the subsequent restart, it vanished on its own.
Bingo! We’ve got a winner. The ECU has some code stored in it. It can be quite insignificant or it might be bigger. You can safely disregard it if the car is operating normally. I’ve had this light continuously even though my corona lights and angel eyes have been out for ages.
What does the caution light for high beams mean?
If the high beam flash function is on or your car’s high beam headlights are on, the high beam light indicator light will be lit.
What does the meaning of the A-shaped headlight sign mean?
When the light is no longer detected, the high beams will turn back on. An automatic headlamp dimmer malfunction alert symbol, this variant. It is shown in yellow and amber. Inside the headlamp is the letter A for Automatic, and on the side is an exclamation point.
What does the triangle on my BMW with the exclamation point mean?
You may have noticed the enigmatic BMW Triangle With Exclamation Point that appears on your dashboard if you own a BMW. Why does that matter? Is there a problem with my car? You’re not the only one who has wondered what this symbol represents, so don’t worry. What the BMW Triangle With Exclamation Point implies and how to resolve it if there is a problem are both covered in this blog post.
When a fault is found, the BMW Triangle With Exclamation Point appears on the dashboard. It is BMW’s approach of alerting the motorist to a potential problem and advising them to take their car to a BMW dealer or repair facility to be looked at. The triangle might also show up if the car’s brakes, tires, or suspension aren’t working properly.
Don’t freak out if you see the BMW Triangle With Exclamation Point. As soon as possible, take the vehicle to a BMW dealer or service facility so they can identify and address the issue. The issue is typically small and simple to resolve. If the issue is not resolved, it can develop into something more significant in the future.
Why does the light on my high beam indication stay on?
Your description makes it sound like your headlights are unaimable or misaligned. For high beams that act as low beams, check the power and ground connections; high resistance on either can result in that situation.
How do I disable the wavy lines on my car?
Depending on your vehicle’s manufacturer, this might change. If available, a switch or button should display a picture of a car with wavy lines underneath.
Once the TC is now turned off, this should show up as a continuous yellow light on the dash.
Depending on the year/model, on a Ford you can either push and hold the traction control button or use the steering wheel controls on the instrument cluster to navigate the menu. To access “settings,” use the down arrow while looking left and pressing the back arrow on the left side of the steering wheel. After selecting “ok,” choose “Driver Assist” by hitting “ok” once more. The word “Traction Control” will then show; press “OK” once again on the steering wheel.
Volkswagen owners should switch the vehicle to auxiliary mode (ignition on but not engine). Press the triangle button to activate the hazard warning lights, then depress the gas pedal five times. The TC will switch back on automatically when the car moves 5 feet. On some VWs, this might not be possible.
Keep in mind that occasionally this may also turn off other safety functions, including trailer sway control (if equipped).
Why does my car have a yellow exclamation point?
Low tire pressure is indicated by the horseshoe-shaped dashboard light, which frequently has an exclamation point in the center.
Low tire pressure develops over time as a result of driving. Low air pressure is also a result of the compressed air inside your tires during cold weather. In the worst situation, your tire may have a nail that is letting air out and needs to be patched as well as refilled. Low tire pressure when driving can affect your car’s handling, put your tires and rims at risk, and result in poor fuel economy.
Driving while your low tire pressure light is on is it safe? Safety issues can arise from poor vehicle control, especially in bad weather. A tire blowout or rim damage are additional risks. Thankfully, a lot of mechanics make getting free tire pressure checks and refills simple. Tire pressure checks and refills are complimentary with every oil change at Chapel Hill Tire. When you purchase tire protection from our professionals, you can also receive no-cost refills for the life of your tires.