When there is an issue with the restraint system, your BMW airbag light stays on and won’t go off while you are driving.
If the Supplemental Restraint System (SRS) has a fault and your BMW airbag light is on, an accident may result in the airbags failing to deploy.
In This Article...
How can the airbag light be turned off on a BMW?
Could you please explain how to turn off the airbag light on my BMW X5? Every time I turn on my car, it has been coming on, and I have no idea how to turn it off. I’m hopeful that resetting the light will solve the problem.
In less than two minutes, find out if your auto insurance is being overcharged.
Unquestionably, resetting your airbag light is a solid first move. Observe these steps to reset the airbag light on your BMW X5:
- Upon starting your automobile, check to see if the airbag light is on.
- Then, after seven seconds, restart your vehicle.
- Two more times, repeat this procedure. Your airbag light ought to disappear.
It is advisable to have someone check over your car for you if the airbag light starts to illuminate once more. Given that sensors are frequently the subject of auto recalls, there may be an issue with the sensor or the airbag itself. The airbag will protect you and any passengers in the event of an accident.
The Jerry app makes sure you are prepared for the aftermath while airbag maintenance makes sure you are prepared for an accident.
The Jerry app, a registered broker that provides end-to-end support, compiles reasonable rates, assists you in switching plans, and even assists you in terminating your old policy.
Why is my BMW’s airbag light on?
What it appears to be: A passenger seated in a chair with a seatbelt fastened holding a circle in their lap. The “SRS” symbol is illuminated in the dash of some cars.
What it means is When a problem is identified by your BMW’s computers within the airbag control unit, the airbag system, or supplemental restraint system (SRS) light will illuminate. If the SRS warning light is on, the system has been turned off, and the airbags won’t inflate in the case of a collision.
What to do if it comes on: When a car starts up, this light will briefly illuminate in the dash before going off, signaling that everything is working as it should and making it safe to drive.
Check to see if anything is obstructing the seatbelt click switch or if anything is piled up behind the seat, which could harm the wires, if the SRS light remains illuminated after starting the car or while it is in motion. If nothing is discovered, visit a local independent BMW repair facility as soon as possible to have a professional inspect and identify the issue. This is not something to be taken lightly, and it is safer to get this issue looked at by a certified BMW mechanic than to jeopardize your safety and the safety of your passengers by driving while it is still active.
How to turn the light off: After you bring your BMW to your neighborhood BMW shop, your mechanic will examine the component and the wiring, run code checks, and perform any necessary repairs.
An illuminated SRS light may indicate a sensor issue, the need to reset your airbags (for instance, if you were recently in a collision and the sensors were activated but the airbags did not deploy), or an issue with the seatbelts. Checking car bulletins is a good idea because there may be other instances when your airbags need to be recalled.
What is the cost of turning the airbag light back on?
Reset Airbag Light, at No. 1 Although it typically costs a few hundred dollars and takes several hours, depending on the type of automobile it might cost as much as $600.
How do I activate my airbag light?
The airbag light connects the seat belt system and the airbag system as part of the Supplement Restraint System (SRS) in automobiles (and vice-versa). When you turn on your automobile, the airbag light comes on for around seven seconds before going out, signifying that the internal system check was successful and finished. When the airbag light either never turns on or stays on while blinking, an issue exists. The airbag light needs to be reset at this stage.
Examining seat belt components, fixing bad clock springs, and replacing faulty sensors are a few techniques for turning off an airbag light. New bulbs or a fully charged battery are other options. While most repairs can be done without a professional, others may.
The following 10 steps will reset your airbag light:
- Turn on and off your ignition.
- Test drive your car when it has been restarted.
- Check the airbag switch for the passenger.
- Check to see if the seat belts are in place and functioning properly.
- Check to see if the passenger seat sensor is off.
- Use a scanner with the ability to reset the SRS or airbag light.
- Fix the broken airbag sensors.
- Replace or repair a broken clock spring.
- Check to see if the airbag is working properly.
- seek for a specialist’s help.
Although not exhaustive, the list above includes tried-and-true methods for tackling the problem. Some of them might not apply to your vehicle because compatibility is always based on the year, make, and model. It is recommended that you have your service manual on hand when carrying out any of these fixes. Always follow the manufacturer’s recommendations, too. Let’s get started on resetting your airbag light right away.
Can the airbag module be reset?
After receiving your repaired module from us, you won’t need to take it to the dealership for additional programming because we reset all fault codes.
Except for modules that were harmed by a flood, fire, or another type of hardware damage, all airbag control modules can be reset and reprogrammed.
Accident-related hard and soft codes are stored in airbag control modules. The module that activates the airbag light will keep error codes even after minor incidents. To turn off the airbag light, we reset and erase all of these crash codes from the computer module.
By removing the battery, is it possible to restart the airbag light?
Without a scanner, most automobile models make it difficult to reset the airbag light. This is a safety warning since, when the airbag light appeared, you should always fix the problem. Fortunately, if you fix the issue, the airbag light will typically also turn off by itself in many automobile models.
However, in some older vehicles, the airbag light can be reset without a scanner by disconnecting the battery wires.
Make that there are no loose wires or rust in the connector plugs in the wiring system under the driver’s or passenger’s seat. Restart your car after spraying an electronic cleaner on the connecting plugs.
If you can’t detect any issues there, you should really invest in an OBD2 scanner or have a shop interpret the codes because otherwise you’ll have to guess what the issue is.
Why won’t my airbag light activate?
The backup battery is dead. It is the most frequent cause of an airbag light that won’t go off. It might take place if your car’s battery is running low or has been depleted for any other cause. Once the battery is fully recharged, the issue will be resolved. But the battery might still be in place.
Why is the light on in my passenger airbag?
When this light illuminates, a system issue has been found, and one or more airbags may not deploy in the event of a collision. Even while it’s feasible for all airbags to function as intended even with an SRS warning light, an airbag malfunction is a serious safety risk.
What could turn on the airbag light?
The spring is intended to preserve continuity between the wiring and the driver’s airbag and coils throughout your steering wheel. The spring may wear out and fail over time, turning on the airbag warning light. Older autos are more likely to have this flaw.
The important line is that you must stop driving as soon as your airbag light illuminates and have your automobile inspected by a repair as soon as possible. Your airbags won’t activate until the issue is identified and remedied. Never disregard your airbag light since your safety and the safety of your passengers are top priorities.
Dashboard Warning Lights Explained, which offers guidance on a variety of lights and their meanings, is a good resource if you want to learn what additional warning lights represent and what to do when they illuminate.
Are the airbags from BMW being recalled?
The newest update in the ongoing Takata airbag recall disaster comes from BMW, which has issued a new recall for almost 4,500 variations of its 3 Series sedan and wagon for model years 1999-2001. This recall follows one from November 2019. This time, albeit the affected vehicles had undergone an inspection, the problematic inflators had not been changed.
The original flaw included a Takata manufacturing problem that led to leaky seals in driver-side airbag inflators made without azide. As a result, the inflator propellant might have been damaged by moisture and could either inflate too forcefully, sending shrapnel into the cabin, or too slowly, failing to protect the driver in an accident. The non-azide inflators use a different explosive chemistry that also allows for the chance of underinflation, but the first risk is comparable to that of the original Takata recall of its inflators utilizing ammonium nitrate propellant.
The 3 Series variations listed here are among the 116,000+ vehicles recalled in late 2019: the model years 2000–01 323Ci, 325Ci, 328Ci, and 330Ci; 1999–2001 323i, 328I, 330I, and 330Xi; and model years 2000 323i and 328I wagon.
Dealers will provide a free replacement inflator that has a redesigned design. Owner notification letters are anticipated to be mailed out starting on July 19, but anyone with more inquiries should contact BMW at 800-525-7417 or the vehicle safety hotline of the National Highway Traffic Safety Administration at 888-327-4236. In order to check their vehicle identification number and learn more, they can go go to the NHTSA website.
Where is the switch for the passenger airbag?
If the vehicle has a switch called the Passenger Airbag Cut Off Switch, it can be used to deactivate the passenger airbag (PACOS).
When the passenger door is open, you may access the switch for the passenger airbag on the passenger side of the instrument panel.
ALL FRONT-FACING PASSENGERS (CHILDREN AND ADULTS) CAN SIT SAFELY ON THE PASSENGER SEAT WHEN THE AIRBAG IS ACTIVATED.
Rear-facing child seats are safe for use on the passenger seat when the airbag is switched to OFF.
Can a blown fuse turn on the airbag light?
Only if the blown fuse is directly connected to the airbag system may it cause the airbag light to turn on and off. Although this is the primary reason for this light, other problems can cause an airbag light to suddenly come on.
The airbag system can malfunction, you can interfere with the seat belt sensor, there is a broken clock spring, there is damaged cabling under the seat, the computer system receives incorrect data, or the sensor was damaged in an accident, which can cause the light to turn on and off.
How is a service safety restraint reset?
This process is intended to assist with resetting the Toyota RAV4’s service safety restraint system. However, it can also be used in a variety of automobiles, regardless of their various makes and models.
However, if this method doesn’t work well for you, make sure to speak with a qualified auto repair or consult your car’s manufacturer’s manual to learn which procedure is appropriate for your vehicle.
- the ignition switch with the key of your car.
- Set the “ignition – ON” position on the key.
- Watch the SRS light as it illuminates for 7 seconds before turning off again.
- the “ignition – OFF” setting by turning the key.
- Give the system three seconds or so.
- Repeat the earlier stages (from 2 -5)
- Start the car’s engine at this point.