If you haven’t already changed the battery in your BMW and don’t know how to do it, here is a quick method. There are nine steps that make up the battery replacement process:
- Remove your key from the ignition after turning it off. Next, find your battery. In a BMW, where is the battery? The majority of the time, you can discover it within your trunk, either on the floor or on the right side. Located it? The battery liner should be removed.
- With a 10mm wrench, unplug the negative battery terminal right away, then store the cable.
- The cable must then be disconnected from the positive battery terminal. To complete the task correctly, lift up the red plastic cover and look for a 10mm nut; you must loosen it.
- The time has come to remove the brackets. Two brackets, one on top and one on the side, support the battery. First, you should unbolt the latter using two 13mm bolts.
- Take out the battery from the trunk, but be careful because it could be heavy.
- Take images of the battery’s model number and technical specifications before you install the new battery. When registering your battery, the BimmerTech expert will need this information very much.
- Now that the old battery has been removed, gently set the new one in its place. Just make sure the settings are correct.
- crucial step Secure the battery properly. You must reinstall the brackets in order to accomplish this, being careful not to overtighten them. If not, you could break the battery housing. Connecting a Liquid Lead-Acid battery to the vent house can stop the vent house’s gasses from accumulating within your trunk if you’re installing one.
- Finally, connect the battery terminals by connecting the positive battery terminal first, then the negative terminal, after cleaning the battery posts with a battery terminal brush.
NOTE: Purchase our Battery Registration service before you ever begin replacing or registering your battery, and choose a preferred date when you could replace and register the battery simultaneously. Make sure you can do everything in one day because battery registration is required following every battery change and needs to be done immediately after battery replacement.
In This Article...
Notes
- You can use a trickle charger to keep the car running while changing the battery in order to preserve the memory features on your BMW. Under the hood, you connect the positive and ground terminals of the backup power. The terminals needed to jumpstart your BMW are these. Be very careful when utilizing a backup source to prevent the positive terminal from shorting to the body or the ground once you remove it from the battery. To prevent the positive terminal from unintentionally touching any other metal body components, tape it down.
- Keep the key released at all times and always remove it from the ignition.
- Stick with AGM battery types whenever possible if your BMW has an AGM battery fitted at the factory. The battery capacity specified in ampere-hours, or Ahr, is another crucial component you need to take into account. Don’t convert to a 60Ahr battery if your BMW has a 90 Ahr battery.
- These requirements are essential since changing one of them necessitates reprogramming your BMW so that it understands how to charge the new battery. Additionally, you still need to register the battery. All of the charge profiles for the old battery are deleted upon battery registration. Call your dealer and ask what battery your BMW needs if the wrong battery was installed by the previous owner.
How can I get a new BMW key?
- Go to a nearby BMW shop like BMW of Bloomington.
- The 17-digit VIN number of your car, which can be located in the driver’s door jamb or close to the front of your windshield, will be required by the technician.
- To have BMW mail you the replacement key, you’ll have to pay a charge.
Can I replace my own BMW battery?
Do you not adore your BMW? And you intend to continue using it for as long as possible, right? Change your oil, replace your air filters, and do other routine maintenance on your BMW as needed to ensure its longevity. Maintaining the battery in your BMW, however, is the one item that contributes the most to flawless operation of your vehicle.
However, a lot of individuals ponder whether BMW battery replacement and registration are straightforward do-it-yourself tasks or require the services of a qualified specialist. We affirm that you can manage the replacement on your own. However, if you lack computer literacy, let us handle the registration process on your behalf.
Here, we’ll go over how to install a battery in a car, examine BMW battery registration in further detail, and provide additional information on the BMW battery reset process.
The cost of a BMW key fob
The price of a 2020 Toyota Sienna fob was comparable. Dealers, however, gave prices as low as $150 to replace a key fob for a 2017 Honda Accord. A number of BMW retailers claimed that the additional security features built into the 2020 X5 key fob justifies the roughly $500 they spend to replace and program one.
How much does a new BMW key battery cost?
I recently visited the business. The key fob wouldn’t work to lock or unlock my car when I tried. My BMW key fob’s battery has to be changed.
In less than two minutes, find out if your auto insurance is being overcharged.
Batteries for key fobs typically last three to four years. Your current BMW key fob might need to be replaced, depending on the model.
You should replace the battery in your smart key or Comfort Access BMW key fob by following these simple instructions:
- Get a CR2032 battery from a department or auto store. It will cost you around $2 to buy it.
- By depressing the tab on your key fob, you can take the valet key off.
- To pry open your battery cover, use the key or a flathead screwdriver.
- Replace the old battery with the new one after removing the old one.
- Restore the key to its housing and close your key fob.
You have a non-comfort access key fob if you are unable to open it because it has an indent in the side. You must take a long drive to recharge your key fob battery because it can only be done through the ignition of your automobile.
Once the battery has been successfully replaced or recharged, make sure to test it by locking and unlocking the doors several times. To find out how much you can save on your auto insurance before you leave again, take a moment to glance at the Jerry app.
The Jerry app, a registered broker that provides end-to-end support, compiles reasonable rates, assists you in switching plans, and even assists you in terminating your old policy.
Is driving a BMW key charged?
Which charging methods are the simplest for my BMW E90 key fob? I have never owned a vehicle with a rechargeable key fob, therefore I have no idea what I’m doing.
BMW gives you the option to swiftly and conveniently recharge the fob rather of manually changing the battery, as you would with a conventional key fob, which would add to environmental waste. Your BMW E90 key can be charged two different ways.
The ignition of the car can be used to charge the key. While driving, you can recharge the battery in your BMW key. A magnetic coil for charging is a component of the ignition. Put your key in the ignition and turn it to positions 1 or 2 to charge it. The battery will start charging on its own.
The length of your drive will determine how much the key will cost. Your key will charge more the longer you drive. This charges the key sufficiently to be pressed 15 times, for instance, if you drive for at least 30 minutes.
Using a portable, inductive charging pad is method number two. If you have a wireless phone charger, you can use it to charge your BMW fob in addition to your phone. Place the key on top of the charging pad to charge it, and leave it there for several hours or overnight.
If you have a smartwatch charging station, you can also try charging the key by placing it on it.
Just like using the Jerry app to save money on your car insurance, charging your BMW E90 key is a breeze. Jerry, a certified broker, conducts all the legwork to obtain more affordable estimates from the top-tier insurance providers, purchase new auto insurance, and even assist you in canceling your current policy!
Can you locate a misplaced BMW key?
Nope. There is nothing you could do to make the fobs detectable even if there was a means to start reverse communication because they lack a speaker.
What occurs if my BMW battery is not registered?
The car will overcharge or undercharge you if you don’t register it with it. When you install a new battery, the automobile will overcharge it since older batteries receive more charge than fresh ones, which causes your battery to die sooner.
Can a BMW be jump-started safely?
DO NOT let any roadside assistance agency install a new battery in your BMW, and DO NOT jump start the vehicle. It might cost more than any other battery or jump start you’ve ever purchased.
What occurs if the battery in your BMW key dies?
You won’t be able to use keyless entry or remote unlocking if your BMW has Comfort Access if the battery in your key fob has died. You can still enter and manually start your automobile, though.
Press and hold the key release button at the remote fob’s base while unlocking the door of your car, then slide out the internal key blade. This can be used in place of a standard key to unlock your car. You can locate a little hole on the bottom of the handle if the keyhole is hidden on your car door. Use the key blade to pry off the trim panel and expose the keyhole by inserting it into the hole.
Once you’re inside, put your remote key fob in the ignition slot or, if your car doesn’t have one, press it up against the steering column’s key markings. If your key fob dies, you will still be able to start your BMW using the start/stop button on the dashboard.
How long is the warranty on a BMW battery?
Considering that all replacement BMW batteries are covered by a two-year/unlimited-mileage warranty*, it only makes sense to select dependable genuine equipment.
The best way to start a car without a key
Remove the electronics from the plastic cover that is located underneath the steering wheel. Then, pound or drill a screwdriver into the ignition flaps until it is firmly in place. The screwdriver should then be turned in the same way as an automobile key. This will begin the vehicle.
Should I reprogramme my car after changing the battery?
No, usually you don’t need to reprogramme your car following a battery change. But if your vehicle has an onboard computer, you might need to reset it.
In addition, This implies that you are not need to purchase a BMW battery if your car’s battery has to be replaced and any replacement battery that fits your car will work. The car’s computer will automatically alter the charging procedure if you purchase a BMW battery, though, to ensure the battery lasts as long as possible.