A significant component of a vehicle’s electrical system is the car battery. In essence, it serves as a form of electrical energy storage for the car’s electric components. Keeping the battery in good working order is therefore important. Sadly, a car battery will ultimately lose its usefulness because it is not a permanent component. More specifically, the battery’s internal chemical processes will come to an end and no energy will be generated. The lifespan of a battery is only 3 to 5 years before it starts to lose its ability to keep a meaningful charge. This suggests that replacing the battery is recommended. Some times the soil will focus on the connection spots, wasting the battery’s energy. Corrosion, a whitish substance that builds up over time on battery terminals, can result in poor connection connections. This is the cause for the battery’s loss of the benefit of alternator recharging. It will eventually run out of energy and stop producing electricity. The battery may resume its normal operation and become useable by clearing soil from the wire and battery connectors. If the automobile hasn’t been driven for a while, the battery can also run out of power. In this situation, recharging the battery will probably make it efficient again. You’ll need a battery charger before you can start the recharge.
Important! It’s possible that some BMW X1 (E84) automobiles have an IBS (Intelligent Battery Sensor) technology installed. That indicates that your Service center has to register the newly replacement battery. Avoiding battery registration could result in a failure of the power management system and inaccurate readings on the on-board computer’s display.
*Note: If more than one battery type is appropriate for your model, compare the specifications of the battery that is already installed in your car to those in the table below before selecting the best one.
Typically, the following equipment is sufficient for replacing batteries:
- 10 and 13 mm sockets or wrenches
- screwdrivers with flat-head and Phillips heads
3. The BMW X1 battery is hidden beneath the carpet in the trunk’s baggage compartment.
Disconnect the negative connection on the old battery before removing it to begin replacing it. By doing this, unintentional short circuits between the positive battery terminal and the car’s body will be avoided. Make sure the cable does not make touch with the battery terminals when changing the battery. The minus (-) sign next to the negative battery connector serves as a visual cue (1):
1. Remove the positive terminal cover:
Positive connection disconnected:
Disconnect the battery’s venting pipe if it’s there (1). Some vehicles use battery ventilation systems to exhaust hydrogen-containing generated gases outside.
Remove the old battery from the battery compartment (notice that the battery is heavy and improper lifting could cause back injuries):
Before installing the new battery in the car’s battery compartment, do not remove the plastic terminal caps.
To guarantee optimal contact, if necessary, clean battery wires of any corrosion or debris before joining.
Instead of unplugging the battery, connect the cables, beginning with the positive terminal.
In This Article...
How to repair a BMW battery
If you haven’t already changed the battery in your BMW and don’t know how to do it, here is a quick method. There are nine steps that make up the battery replacement process:
- Remove your key from the ignition after turning it off. Next, find your battery. In a BMW, where is the battery? The majority of the time, you can discover it within your trunk, either on the floor or on the right side. Located it? The battery liner should be removed.
- With a 10mm wrench, unplug the negative battery terminal right away, then store the cable.
- The cable must then be disconnected from the positive battery terminal. To complete the task correctly, lift up the red plastic cover and look for a 10mm nut; you must loosen it.
- The time has come to remove the brackets. Two brackets, one on top and one on the side, support the battery. First, you should unbolt the latter using two 13mm bolts.
- Take out the battery from the trunk, but be careful because it could be heavy.
- Take images of the battery’s model number and technical specifications before you install the new battery. When registering your battery, the BimmerTech expert will need this information very much.
- Now that the old battery has been removed, gently set the new one in its place. Just make sure the settings are correct.
- crucial step Secure the battery properly. You must reinstall the brackets in order to accomplish this, being careful not to overtighten them. If not, you could break the battery housing. Connecting a Liquid Lead-Acid battery to the vent house can stop the vent house’s gasses from accumulating within your trunk if you’re installing one.
- Finally, connect the battery terminals by connecting the positive battery terminal first, then the negative terminal, after cleaning the battery posts with a battery terminal brush.
NOTE: Purchase our Battery Registration service before you ever begin replacing or registering your battery, and choose a preferred date when you could replace and register the battery simultaneously. Make sure you can do everything in one day because battery registration is required following every battery change and needs to be done immediately after battery replacement.
How is the battery taken out of a BMW X1?
Lift up on the panel covering your battery after opening the trunk. Remove the negative battery terminal’s bolt with a 10mm socket, remove the terminal from the battery post, and place a barrier between the post and the terminal (microfiber towel will work). Reverse directions to rejoin
On a BMW X1, where is the battery located?
You’re not the only one who wonders where the battery in your BMW X1 is. There is a solid reason why so many people are interested in where their car’s battery is located.
Since the battery is a crucial part of any car, it’s necessary to know where it is in case you need to jump start your vehicle or replace it. The BMW X1’s engine compartment is on the right side of the vehicle, and this is where the battery is placed.
It features a black cover with the BMW logo on it, making it simple to identify. Simply take off the cover and release the two bolts holding it in place to gain access to the battery.
The battery can then be removed from the vehicle once you have disconnected the negative and positive terminals. The positive battery terminal should be connected to the positive terminal of the jump-start kit, and the negative battery terminal should be connected to the negative terminal of the jump-start kit if you need to jump-start your BMW X1.
You ought to be able to start your vehicle once the battery is connected. Contact your neighborhood BMW dealer if you need assistance jump-starting your BMW X1 or if you have any queries regarding where the battery is located in your vehicle.
In the 2017 BMW X1, where is the battery?
The X1’s battery was shifted from the back of the car to the front as it transitioned from a rear-wheel drive to a front-wheel drive platform. It is now located just in front of the windscreen and behind the engine.
How can I reset my BMW now that the battery has been changed?
Here are the instructions so that you can see how crucial the BMW computer reset is after reading the preceding explanation.
- Once the lights and radio are turned on, first switch the ignition key of the BMW automobile to the accessory position. This must be completed prior to starting the car. Then, hold down the “Trip” button on the instrument panel for a few seconds until the red light appears.
- Once more, press and hold the “Trip” button until Reset appears.
- Press the same button a third time after that. The BMW computer will quickly reset now.
BMW automobile battery replacement and computer reset are both inexpensive procedures. The sooner you complete this, the easier it will be for you to operate your BMW vehicle. Despite all of these facts, this surgery should not be taken lightly. There are auto repair shops with qualified experts who adhere to the manufacturer’s warranty guidelines. To receive a safe and secure service, consult these businesses.
Can I change the battery in my BMW myself?
Do you not adore your BMW? And you intend to continue using it for as long as possible, right? Change your oil, replace your air filters, and do other routine maintenance on your BMW as needed to ensure its longevity. Maintaining the battery in your BMW, however, is the one item that contributes the most to flawless operation of your vehicle.
However, a lot of individuals ponder whether BMW battery replacement and registration are straightforward do-it-yourself tasks or require the services of a qualified specialist. We affirm that you can manage the replacement on your own. However, if you lack computer literacy, let us handle the registration process on your behalf.
Here, we’ll go over how to install a battery in a car, examine BMW battery registration in further detail, and provide additional information on the BMW battery reset process.
How long does a BMW X1 battery last?
Your BMW X1 battery will typically last between three and five years, however actual battery life can vary greatly based on factors including battery size, type, weather, and driving style.
How can the computer on a BMW x1 be reset?
The mechanic will reset the computer in your BMW after the service is complete so it can record your mileage and let you know when the car will need maintenance again in the future. However, the techniques listed below can help you if you maintain your own car but are unclear of how to reset the computer system.
- With the engine off, turn the key to the ON position.
- For TEN seconds, press and HOLD the ODOMETER button. It can be found at the Instrument Cluster’s extreme bottom LEFT corner.
- The dash screen will display FGSTNR along with a number. Your chassis number is this (See image example).
- The LAST FOUR numerals are added. Ex: 3+4+5+6= 18 (taken from the image above). Your UNLOCK CODE is going to be 18.
- Press and hold the ODOMETER button one more until the FGSTNR clearing area appears (you will still see numbers in the top section).
- Press the odometer button until the upper Menu area (entering code menu) reaches 19 after the bottom area has cleared; When you do, the text will appear at the bottom: Press the odometer button to enter your unlock code after turning the lock on (from the example above) This is seen in the bottom portion.
- The screen will appear as in the image above after a little period, at which point the menu will once again appear at the top. To access the number 21 menu, press the odometer button (also theentering code menu).
- On the screen’s bottom, it will say: RESET? To complete the reset, press the odometer button.
Your BMW’s computer has been restarted! The existing settings must now be added again, or new ones must be added.
**NOTE: Slowly repeat the procedures if you are unable to reset the BMW computer on your first attempt. If you’re still having trouble, ask the dealership for help or refer to your car’s owner’s manual.