Full synthetic SAE 5W-40 motor oil from Valvoline for European vehicles, 1 quart
In This Article...
What type of oil can I use in a 2013 Volkswagen CC?
OE Recommendation, Full Synthetic Castrol EDGE Engine Oil 5W-40 5 Quart Notes 5W-40. 5 quarts of space.
Engine Oil
All TEMPS….5W-40, 5W-30 – Use a viscosity grade appropriate for the climate, season, and driving circumstances where the vehicle is operated if synthetic oil that satisfies the relevant Audi, Volkswagen oil quality standard with the suggested viscosity grade is not readily available in your area. Verify that the oil satisfies the requirements for Audi and Volkswagen.
Capacity:
4.9 quarts with filter. Add 0.5L (0.5 qt) less than the indicated capacity, turn on the engine, and let it run until the operating temperature is around. 60 C (140 F), turn off the engine, wait three minutes, check the dipstick, and fill to the full mark as shown on the dipstick. Depending on the model, may be more or less than 0.5L (0.5qt).
Torque:
Oil Drain Plug…22 ft/lbs After each removal, replace the drain plug with a fresh one.
A 2012 cc uses how much oil?
Amsoil is a high-tech oil that surpasses the competitors! For your Cc, get the best.
Add 0.5L (0.5 qt) less than the capacity shown to the filter’s 4.9 quarts, start the engine, and let it run until the working temperature is almost reached. 60 C (140 F), turn off the engine, wait three minutes, check the dipstick, and fill to the full mark as shown on the dipstick. Depending on the model, may be more or less than 0.5L (0.5qt).
Does VW need synthetic motor oil?
Any Volkswagen car produced after 2004 must use synthetic oil due to their distinctive design. The reason for this is because a VW engine’s valves are built differently from those in most other cars and are more likely to clog up with contaminants contained in regular oil.
When should I replace the oil in my VW CC?
For standard oil, VW suggests changing your VW CC’s oil and filter every 3,000 to 5,000 kilometers. Typically, synthetic oil needs to be changed every 7,500 to 10,000 miles. Remember that the best way to figure out the intervals for your car is to consult the owner’s manual and the dealer.
CCDiesel Engine Service
A few naturally aspirated, turbocharged, or supercharged diesel engines used in moderate- to severe-duty operation as well as a few heavy-duty gasoline engines fall under the category CC. In these diesel engines, high-temperature deposits and bearing corrosion are protected by oils developed for this purpose, and gasoline engines are similarly protected from rust, corrosion, and low-temperature deposits. These oils first became available in 1961.
CDDiesel Engine Service
The term “category CD” refers to service that is typical for some naturally aspirated, turbocharged, or supercharged diesel engines, or when a wide variety of high-quality fuels, particularly high-sulfur fuels, are used and highly effective wear and deposit control is required. In these diesel engines, oils created for this use offer protection against high-temperature deposits and bearing corrosion since they were first introduced in 1955.
CD-IISevere Duty Two-Stroke Cycle Diesel Engine Service
Two-stroke cycle diesel engine maintenance calls for extremely good control of wear and deposits. The performance standards of API Service Category CD are also met by oils created for this service.
CE1983 Diesel Engine Service
Service usual for some heavy-duty diesel engines with turbochargers or superchargers built after 1983 and used in low-speed, high-load and high-speed, high-load scenarios. When API Engine Service Category CD is advised for diesel engines, oils created for this service may also be utilized.
How can the oil life of a 2014 Volkswagen CC be reset?
- Using the controls on the steering wheel or the windshield wiper arm, select the “Settings menu.”
- To reset the display, select the “Service submenu, then the “Reset option, and finally click the OK button.
- To confirm, press the OK button one more time.
- The 0.0/ SET button should be depressed and held when the ignition is turned off.
- Turn the ignition to the ON position while continuing to hold down.
- After momentarily pressing the CLOCK setting button (found on the left side of the instrument cluster), release the button.
- The display will return to its regular state after a brief interval, signaling that the service interval has been reset.
The amount of oil required by a Passat 2.0 TDI?
Start adding the needed VW 507 00 standard engine oil to the engine. This Volkswagen 2.0-liter TDI diesel engine has a 5-and-a-half-liter oil fill capacity.