The four bolts holding the fuel pump access cover need to be loosened and removed. The gasoline pump may be seen by raising the access cover.
Grabbing the fuel pump’s electrical harness is a good idea. To unplug the harness, push the locking button and pull it up.
Allow the car to keep going until it stalls. By doing this, all gasoline pressure is released from the lines. Activate the “Off” position on the key.
Using the ratchet and socket, remove the negative battery cable from the Galant’s hood.
Banjo bolt attaching the brake line to the top of the gasoline filter should be loosened and removed. Use a line wrench to hold the nut on the fuel filter while turning the bolt with the ratchet and socket. The fuel filter is mounted to the firewall and is situated in the engine compartment on the rear passenger side.
Using two line wrenches, loosen and remove the main line that enters the gasoline filter’s bottom. Turn the nut on the line with one wrench while holding the connector on the gasoline filter with the other.
Pull the gasoline filter out of the car by loosening and removing the two bolts holding it to the firewall of the Galant.
Put the new filter in this bracket after removing the old one from the metal bracket that surrounds it. Ensure that the new filter is installed in the exact same location as the previous one.
Using two line wrenchesone to tighten the fuel line and the other to secure the filter’s connectorplace the main fuel in the bottom of the fuel filter and tighten it.
With the new gaskets that come with the fuel filter, insert the fuel line into the top of the filter. The banjo bolt should be torqued to 22 foot pounds. To tighten the bolt, use a torque wrench and socket; to hold the gasoline filter nut, use a line wrench.
Using a torque wrench as a socket, tighten the mounting nuts holding the gasoline filter to the firewall to 10 foot-pounds.
Through the fuel pump access hole on top of the fuel pump, insert the electrical harness.
Reinstall the access panel over the fuel pump, then use a ratchet and socket to tighten the nuts.
Place the rear of the cushion under the seat-back cushion before pressing the front of the cushion down until it clicks into place to reinstall the rear seat cushion.
In This Article...
Where is the Mitsubishi Eclipse’s fuel filter located?
Always look for the fuel filter between the fuel tank and the engine. The fuel filter is often found within the top of the fuel tank, just where the fuel line enters the vehicle. However, on other vehicles, the fuel filter may be found somewhere else along the fuel line.
In a 2003 Eclipse, where is the fuel filter located?
The fuel filter is mounted to the firewall and is situated in the engine compartment on the rear passenger side. Using two line wrenches, loosen and remove the main line that enters the gasoline filter’s bottom. Turn the nut on the line with one wrench while holding the connector on the gasoline filter with the other.
Where is the fuel filter on a 2007 Mitsubishi Eclipse?
On my Mitsubishi, where is the fuel filter located? Always look for the fuel filter between the fuel tank and the engine. The fuel filter is often found within the top of the fuel tank, just where the fuel line enters the vehicle. However, on other vehicles, the fuel filter may be found somewhere else along the fuel line.
Where is the fuel filter located on a 2003 Mitsubishi Eclipse?
The fuel pump is a component of the fuel filter on the 2003 Mitsubishi Eclipse. The gasoline pump is typically located below the vehicle and is fastened to the fuel rail. It is relatively straightforward to access because it is just secured in place by a few little bolts that are not particularly difficult to take out.
If you know how to replace a gasoline filter, you can do it yourself the next time your car requires a new fuel filter in a quick and affordable manner. Although specifics differ from vehicle to vehicle, the fundamental process is the same as what I have detailed here. $15 to $125 is the price for parts.
A gasoline filter is there on a Mitsubishi Eclipse?
You may finally put an end to your hunt for the ideal Fuel Filter items for your Mitsubishi Eclipse! For your car, Advance Auto Parts has 5 different Fuel Filters available for either in-store pickup or shipment.
Where is the fuel filter?
Either the fuel filter is housed inside the fuel tank or it is attached to the fuel line running from the tank to the fuel pump. Some engines feature non-repairable internal fuel filters.
What signs might point to a clogged fuel filter?
Engine repairs can be expensive and put your car in the shop for a long time. Wouldn’t it be wonderful if there was something simple and cheap you could do to maintain your engine safe and operating smoothly? Wait! It exists! Focus a little more on the fuel filter.
HOW DO YOU KNOW IF YOU’RE DRIVING WITH A CLOGGED FUEL FILTER?
Here are five signs of a malfunctioning fuel filter to look out for:
- You have trouble starting the automobile. If the fuel filter is the issue and it isn’t changed right away, your car might not even start.
- harsh idling or misfire. A clogged fuel filter could make it difficult for the engine to receive enough fuel.
- Stall of the vehicle. Nobody likes to abruptly halt in a busy area! But if you’re operating a vehicle with a filter that has seen better days, that is what might happen.
- failure of a fuel system component. Trying to force fuel through a clogged fuel filter might cause electric fuel pumps to malfunction early.
- gasoline pump noises that are loud. Your car may be trying to tell you something is amiss by making sudden, strange noises.
DRIVE TOO LONG WITH A CLOGGED FUEL FILTER AND THE CHECK ENGINE LIGHT COULD COME ON
Fuel system sensors are found in many cars. The Malfunction Indicator Lamp (MIL) or Check Engine Light illuminates when a fault has been found by the sensors.
The filter needs to be changed in order to address these major issues. To provide dependable drivingability, fuel filters must be maintained consistently and on schedule. A new filter minimizes impurities and aids in avoiding harm to your engine and fuel system.
HOW OFTEN SHOULD THE FUEL FILTER BE CHANGED?
The filter should typically be replaced every two years or 30,000 miles (whichever comes first), but it is just a general recommendation. You may want to change your fuel filter more frequently if you travel a lot on unpaved roads or through areas where there is highway construction, which can kick up a lot of dust and debris. For the suggested interval for your particular vehicle, you should refer to your owner’s manual.
Don’t skip a routine maintenance check, but if you see any of the five signs of a bad gasoline filter described above, don’t wait to have a mechanic examine your car. 2,000 Jiffy Lube sites can be found in North America, and there, a skilled Jiffy Lube technician will:
- Ask about your driving habits to learn how they may affect the fuel system in your car.
- Describe the signs of a bad fuel filter and ask if any of them apply to you.
- Get rid of the used fuel filter.
- Change the old gasoline filter out for a new one that satisfies or exceeds the manufacturer’s specifications.
DON’T NEGLECT YOUR VEHICLE’S OTHER FILTERS
To maintain optimal vehicle performance, filters other than the fuel filter put in a lot of effort. The technician at Jiffy Lube will also visually examine the:
- automobile air filter. The engine air filter shields the engine from impurities in the air, just as the fuel filter aids in removing trash from the fuel.
- filter for transmission. The filter is essential to your automatic transmission’s ability to keep debris and dirt out of the hydraulic system.
- air filter in the car. You and your passengers sit in the cabin, and the cabin air filter helps to clear the air of dust, pollen, and mold so that everyone may breathe more easily.
The Jiffy Lube expert won’t perform any work without your permission but will let you know if any replacement of any type is suggested.
YOU CAN COUNT ON JIFFY LUBE
Your car will continue to run as it was intended if you get routine, expert preventive maintenance performed. Jiffy Lube specialists use high-quality products and have undergone thorough training. This is advantageous to you since it increases the likelihood that your car, truck, minivan, or SUV will be ready to go and continue going when you need it most. Additionally, it’s beneficial to your budget because minor repairs, like changing your fuel filter, won’t escalate into more costly ones if they are discovered early.
Can I replace my own fuel filter?
Several crucial parts of the fuel systems in vehicles keep engines running smoothly. When these parts need to be replaced, it might be the difference between a smooth drive and getting stuck on the side of the road. One of these parts is the gasoline filter.
There are still enough older models that have accessible fuel filters even though a growing percentage of modern cars do not. Experts advise replacing your vehicle’s fuel filter every 30,000 miles or two years, whichever comes first. This is because fuel filters are made to prevent debris, rust, paint chips, and other impurities from getting into fuel injectors and ultimately hurting the engine. Your car has a single gasoline filter, and if you don’t change it, insufficient fuel will reach the engine, which could cause a breakdown.
If you know how to replace a gasoline filter, you can do it yourself the next time your car requires a new fuel filter in a quick and affordable manner. Although specifics differ from vehicle to vehicle, the fundamental process is the same as what I have detailed here.
What function does a fuel filter serve?
Before pollutants, silt, contaminants, and rust have a chance to enter the fuel injection system and ultimately the engine of your car, a fuel filter functions as a permeable barrier that cleans the gasoline of these elements. The fuel filter may be a cartridge that contains paper-based filtration media.