Notes: Conventional High Mileage, OE Recommendation. 5W-30.
In This Article...
Mitsubishi uses oil, why?
Q. With 190,252 kilometres, my 2006 Mitsubishi Outlander is in good condition. I updated the catalytic converters in the past two years, and ever since, the automobile has been burning oil. After getting my oil changed recently, I drove 275 miles before the check engine light appeared. The engine was dry when I checked it. What might the issue be? What do you think of the newest Mitsubishi Outlander, by the way?
A. Your Mitsubishi burning oil is most likely to blame for the catalytic converter failure. Verifying that the positive crankcase ventilation (PCV) system is working properly would be the first and simplest check. Oil use may increase if the PCV system is not operating properly. High engine temperatures, worn piston rings, and harmed valve seals can also contribute to oil consumption. At this stage, I would have the engine given a thorough diagnostic examination by a repair facility. Additionally, compression testing and cylinder leak down should be performed. Regarding the most recent Outlander (2015 model), it’s a really good car with lots of great amenities and a fantastic guarantee, but as a whole, I feel like it lags behind the competition by a few years.
Can I use 5W30 with 5W20?
It is generally not advised to substitute 5w30 oil (or any other oil weight) for 5w20 oil because even a small viscosity change has the potential to harm your engine.
Can I substitute 10w40 for 5w30?
5W-30 oil is not used in your car. According to Kia literature, 10W-40 oil viscosity is advised for your car. You can use 5W-30 oil if the outside temperature is considerably below 32 degrees when you are driving the car, but you can also use 10W-40 if the outside temperature is below freezing. Requesting an engine oil/filter change will have the answering mechanic take care of this for you if you prefer that this maintenance be done by a qualified Mechanic sent directly to your location by YourMechanic. Do not hesitate to get in touch with YourMechanic again if you have any more queries or worries.
Can I use 10w30 for 5w30?
If you are currently using 10W30, you can safely switch to 5W30, according to the API motor oil guide (in car engines). When cold, 5W30 is thinner than 10W30. (You must adhere to the manufacturer’s instructions). However, going from cost-effective 10W30 to 5W30 is not always advised.
Can I use 5w40 for 5w30?
This essentially indicates that each oil is equally viscous at lower temperatures and will remain so at a temperature of 30C, but that 5w40 oil operates better at higher temperatures than 5w30 oil, being effective up to ambient temperatures of 50C as opposed to 30C.
In comparison to, say, 10w40 oils, 5w40 and 5w30 motor oils have winter viscosity grades of five, making them effective down to temperatures of -30C and more viscous at extremely low temperatures.
As a result, 5w40 oils are probably utilized in higher-performance engines that operate at higher temperatures and loads than usual, such as those used in vehicles driven in metropolitan environments, which frequently sit in traffic, or in vehicles traveling at very high speeds, for example.
5w30 oils are a fantastic option if your vehicle is not made to be driven at a high rate of speed or if you drive more cautiously and sustainably. These typically perform better for certain engine parts like oil pumps, can clean the engine better, and have longer lives because they operate at lower temperatures.