The time it takes to conduct repairs can range from three hours to three days. Everything depends on the severity of the damage and whether extra components need to be ordered by the auto shop. Additionally, sensors or cameras that may have been harmed in the collision may need to be repaired at the shop.
Typically, a replacement takes 2 to 5 days. Most likely, the store must place an order for a replacement and wait for it to arrive. To be safe, you might have to keep your car there all night. A defective bumper could cause major damage to the rest of your car if you were to get into another collision.
In This Article...
What goes where in a bumper bracket?
Safety Advice
Always use safety eyewear when performing maintenance on your car. When necessary, put on additional personal protective equipment (PPE), such as latex gloves or closed-toe shoes.
The car’s bumper cover should be taken off. All of the clips and screws securing the bumper cover to the car should be loosened and removed using a tool designed for door trim panels. On the end of the bumper cover in the wheelwell and all along the top and bottom of the cover are the clips/screws.
On the right and left sides of the car, beneath the fender, look for the bumper brackets.
Take the bumper brackets off the car. The bumper brackets are typically fastened to the vehicle using two bolts.
Check for any damage that would prohibit the new brackets from being put in the vicinity of and underneath the bumper bracket site.
Start at one end of the clips or screws and work your way to the other.
Can you swap out a back bumper on your own?
Other drivers on the road present one of the major driving hazards. Nobody wants to halt at an intersection and hear the crushing sound of a good rear-ending from the car behind them. Your rear bumper can withstand the shock and pressure of a collision when traveling at low speeds, but it frequently sustains severe damage from the accident. In such circumstances, you are able to swiftly and simply purchase a spare rear bumper and replace it yourself with a minimum of technical expertise.
With only the most elementary mechanical understanding, one may complete this job, which is pretty simple. A set of spanners or a wrench, a flat-headed screwdriver, and a helper to hold the new bumper in place while you reattach it to the automobile are required to finish the operation at hand.
Can you easily change your own bumper?
You can repair a damaged or rusty pickup bumper on your own. A bumper that is dented or rusted can ruin the overall appearance of a pickup truck that is otherwise in good condition. It will cost $1,000 to have it fixed professionally, but you can do it yourself and save $500 or more on labor and supplies. It only requires a few hours.
How is a bumper removed?
The best way to remove a dented bumper
- The dented bumper should be heated using a heat gun or a hair dryer. For at least 30 seconds or longer, warm the bumper.
- Point the nozzle of a compressed air can at the dent while holding the can so that the bottom is facing up.
- Hold off until the dent emerges.